- Computers & electronics
- Computer components
- System components
- Server/workstation motherboards
- User manual
advertisement
Introduction
1. Introduction
This Technical Product Specification (TPS) provides board-specific information detailing the features, functionality, and high-level architecture of the Intel
®
Server Board S2600IP and Intel
®
Workstation Board
W2600CR.
In addition, you can obtain design-level information for a given subsystem by ordering the External
Product Specifications (EPS) for the specific subsystem. EPS documents are not publicly available and you must order them through your local Intel representative.
1.1 Chapter Outline
This document is divided into the following chapters:
Chapter 1
– Introduction
Chapter 2
– Product Overview
Chapter 3
– Functional Architecture
Chapter 4
– Platform Management Overview
Chapter 5
– System Security
Chapter 6
– Connector/Header Locations and Pin-outs
Chapter 7
– Jumper Blocks
Chapter 8
– Intel ®
Light Guided Diagnostics
Chapter 9
– Design and Environmental Specifications
Appendix A: Integration and Usage Tips
Appendix B: BMC Sensor Tables
Appendix C: Platform Specific BMC Appendix
Appendix D: POST Code Diagnostic LED Decoder
Appendix E: POST Error Messages and Handling
Glossary
Reference Documents
1.2 Server Board Use Disclaimer
Intel
®
Server Boards contain a number of high-density VLSI (Very-large-scale integration) and power delivery components that require adequate airflow for cooling. Intel ensures through its own chassis development and testing that when Intel
®
server building blocks are used together, the fully integrated system meets the intended thermal requirements of these components. It is the responsibility of the system integrator who chooses not to use Intel developed server building blocks to consult vendor datasheets and operating parameters to determine the amount of airflow required for their specific application and environmental conditions. Intel Corporation cannot be held responsible if components fail or the server board does not operate correctly when used outside any of the published operating or nonoperating limits.
Revision 1.2 Intel order number G34153-003 1
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 15 Introduction
- 15 Chapter Outline
- 15 Server Board Use Disclaimer
- 16 Product Overview
- 17 Product Feature Set
- 19 Main Board Connector and Component Layout
- 22 Main Board Rear I/O Layout
- 24 Server Board Mechanical Drawings
- 33 Functional Architecture
- 34 Processor Support
- 34 Processor Socket Assembly
- 35 Processor Population Rules
- 36 Processor Initialization Error Summary
- 39 Processor Functions Overview
- 40 QuickPath Interconnect
- 40 Integrated Memory Controller (IMC) and Memory Subsystem
- 46 Processor Integrated I/O Module (IIO)
- 48 C600-A Chipset Functional overview
- 48 Digital Media Interface (DMI)
- 48 PCI Express* Interface
- 48 Serial ATA (SATA) Controller
- 49 Serial Attached SCSI (SAS)/SATA (SCU) Controller
- 49 Rapid Storage Technology
- 50 PCI Interface
- 50 Low Pin Count (LPC) Interface
- 50 Serial Peripheral Interface (SPI)
- 50 Compatibility Modules (DMA Controller, Timer/Counters, Interrupt Controller)
- 50 Advanced Programmable Interrupt Controller (APIC)
- 50 Universal Serial Bus (USB) Controllers
- 50 Gigabit Ethernet Controller
- 51 Enhanced Power Management
- 51 Manageability
- 51 System Management Bus (SMBus* 2.0)
- 51 Integrated NVSRAM controller
- 52 Virtualization Technology for Directed I/O (Intel® VT-d)
- 52 JTAG Boundary-Scan
- 52 KVM/Serial Over Lan (SOL) Function
- 52 On-board SAS/SATA Support and Options
- 53 PCI Subsystem
- 54 Network Interface Controller
- 54 Network Interface
- 55 Workstation Board W2600CR2L)
- 56 SAS ROC Module Support
- 57 Workstation Board W2600CR Only)
- 60 Platform Management Overview
- 60 Server Management Function Architecture
- 60 Feature Support
- 62 Basic and Advanced Features
- 63 Integrated BMC Hardware: Emulex* Pilot III
- 65 Server Management Functional Specifications
- 65 BMC Internal Timestamp Clock
- 66 System Event Log (SEL)
- 66 Sensor Data Record (SDR) Repository
- 66 Field Replaceable Unit (FRU) Inventory Device
- 66 BMC Beep Codes
- 67 Diagnostic Interrupt (NMI) Button
- 67 BMC Watchdog
- 68 Sensor Monitoring
- 68 Overview
- 68 4600/2600/2400/1600/1400 Product Families
- 69 BMC System Management Health Monitoring
- 70 Processor Sensors
- 73 Thermal and Acoustic Management
- 74 Set Throttling Mode
- 74 Altitude
- 74 Set Fan Profile
- 74 Fan PWM Offset
- 74 Quiet Fan Idle Mode
- 75 Thermal Sensor Input for Fan Speed Control
- 76 Power Supply Status\Health Sensors
- 77 System Event Sensor
- 78 Platform Management Interface
- 79 Channel Management
- 79 User Model
- 79 LAN Interface
- 89 BMC Firmware Update
- 89 The BMC firmware release Number
- 89 Boot Recovery Mode
- 90 Force Firmware Update Jumper
- 90 Fast Firmware Update over USB
- 91 Advanced Management Feature Support
- 91 Enabling Advanced Management Features
- 91 Keyboard, Video, Mouse (KVM) Redirection
- 92 Media Redirection
- 94 Intelligent Power Node Manager (NM)
- 94 Overview
- 95 EU Lot 6 Mode
- 96 System Security
- 96 BIOS Password Protection
- 98 Trusted Platform Module (TPM) Support
- 98 TPM security BIOS
- 99 Physical Presence
- 99 TPM Security Setup Options
- 101 Trusted Execution Technology
- 102 Connector/Header Locations and Pin-outs
- 102 Power Connectors
- 102 Main Power Connector
- 102 CPU Power Connectors
- 102 Add-in Card Power Connectors
- 103 Front Panel Header and Connectors
- 103 Front Panel Header
- 104 Front Panel USB Connector
- 104 Local Control Panel Connector
- 104 On Board Storage Connectors
- 104 SATA Connectors: 6Gbps
- 105 Multiport Mini-SAS/SATA Connectors
- 106 RAID C600 Upgrade Key Connector
- 106 HSBP_I2C Header
- 106 HDD LED Header
- 106 Internal Type- A USB Connector
- 107 Internal eUSB SSD Header
- 107 Management and Security Connectors
- 107 RMM4_Lite Connector
- 107 RMM4_NIC Connector
- 108 TPM Connector
- 108 PMBus* Connector
- 108 Chassis Intrusion Header
- 108 IPMB Connector
- 108 FAN Connectors
- 109 System FAN Connectors
- 109 CPU FAN Connector
- 109 Serial Port and Video Connectors
- 109 Server Board S2600IP only)
- 110 Serial Port B Connector
- 110 Server Board S2600IP only)
- 111 Workstation Board W2600CR only)
- 112 Jumper Blocks
- 113 BIOS Default and Password Reset Usage Procedure
- 113 Set BIOS to default (Clearing the CMOS)
- 113 Clearing the Password
- 114 Force BMC Update Procedure
- 114 BIOS Recovery Jumper
- 115 ME Force Update Jumper
- 116 Light Guided Diagnostics
- 116 5-volt Stand-by LED
- 116 Fan Fault LED
- 116 CPU Fault LED
- 118 DIMM Fault LEDs
- 118 System ID LED, System Status LED and POST Code Diagnostic LEDs
- 119 System ID LED
- 120 System Status LED
- 121 POST Code Diagnostic LEDs
- 122 Design and Environmental Specifications
- 122 Products Design Specifications
- 125 Server Board Power Requirements
- 126 Processor Power Support
- 126 Output Power/Currents
- 126 Cross Loading
- 127 Standby Output
- 127 Voltage Regulation
- 127 Dynamic Loading
- 128 Capacitive Loading
- 128 Grounding