Y BELTTENSION ADJUSTMENT. Roland E-600

4-5 Y BELT TENSION ADJUSTMENT (Referential Time : 10min.)

1

Remove the Y Rail Cover.

Y Rail Cover

4 Adjustment

2

Loosen the Screw1 and 2 and then, loosen the Nut1 and 2.

Tighten up the Nut2 so that there is no gap between the

Frame and the Nut1.

Frame

It is possibe to adjust the X Belt Tension by changing the position of the Nuts.

Screw1

Screw2

Nut1 Nut2

3

Push the Y-Belt with the Tension Gauge (ST-001) at the middle position between the Y-Drive Pulley and check the bending amount with the ruler.

Confir that the Pressing Force matches with the Bending

Amount in reference to the next table.

ST-001

4

Y Belt

EGX-600

EGX-400

<Reference Table>

Pressing Force Bending Amount

720gf 8.0mm

720gf 6.0mm

77

4

4 Adjustment

4

When the Pressing Force matches with the Bending

Amount, tighten up the Screw1 and 2.

If the Pressing Force does not match with the Bending

Amount, adjust the Belt Tension by Nut1 and 2 again. After that, measure the tension and when the Belt Tension becomes to the proper value, tighten up the Nut1 and 2.

Frame

Screw1

Screw2

Nut1 Nut2

78