Step 6 : Connecting the Power cord. Samsung DVD-R120

2_00685A_R120_Eng(14~29) 3/4/05 2:17 PM Page 20

Method 2 : Connecting a Camcorder to the LINE 2 IN jacks

You can also use the LINE 2 IN jacks on the front panel of the DVD Recorder. You can record from connected equipment, such as a camcorder.

When an input source is inserted into LINE 2 while viewing TV, the input will be switched to LINE 2 automatically.

Step 6 : Connecting the Power

Cord

After all connections are complete, plug the power cord in the wall outlet.

“Auto” appears in the panel display. This means that the current time is being set automatically

(Auto Program) through the antenna under connection and also the channel is being set.

The setup may take a few minutes.

When the DVD Recorder operates normally, the current time is automatically set and displayed in the front panel display.

NOTE

■ After the current time is set automatically, the recorder will perform Auto Channel

Memory for about 3 minutes. If power is on, while Auto Channel Memory is in process, Auto Channel Memory will stop.

In this case, do Auto Channel Memory from MENU(see page 25).

Method 3 : Connecting a Camcorder to the DV IN jack

If your camcorder has a DV output jack, connect it to the DV input jack of your DVD Recorder.

NOTE

■ If the input is not selected automatically, use INPUT button to select proper input.

20

- English