Mounting of handle. Dolmar MS34C, MS34U

MOUNTING OF HANDLE

CAUTION: Before doing any work on the equipment, always stop the engine and pull the spark plug connector off the spark plug.

Always wear protective gloves!

CAUTION: Start the engine only after having assembled it completely.

For bike handle models

– Place the handle with the throttle lever on the handle holder on the right side (to be held by the right hand) and the other on the left side.

Fit the handle edge to the handle holder groove, and provisionally fix the upper side (1) of the handle holder by four bolts M5 x 25 (2).

– Adjust the handle to an angle easy to manipulate, and tighten the bolt (2) uniformly on the right and left sides.

(2)

(1)

MS-34 U

For loop handle models

– Fix a barrier (1) to the left side of the machine together with the handle for operator protection.

Make sure that the grip/barrier assembly is fitted between the spacer and the arrow mark (2).

WARNING: Do not remove or shrink the spacer (3). The spacer keeps a certain distance between both hands. Setting the grip/barrier assembly close to the other grip beyond the length of the spacer may cause loss of control and serious personal injury.

NOTE:

In some countries the spacer is not included. In that case fit the grip/barrier assembly between arrow marks.

(2)

(3)

(1)

MS-34 C

9