Usage of door contacts. Alpha Tech IP Bold - VoIP DoorPhone

1.4.3 PoE

The IP BOLD is equiped by circuit for powering via UTP cable – PoE. When you have IP switch with PoE, or you have PoE PSU (box of adapter size inserted into UTP cable input – according directive IEEE802.3af) then you dont need extra 12V PSU for door entry powering.

When you use electrical lock for door opening then you have to use PSU for powering of door electrical lock (in relays contacts circuit only), or use low consumption electrical lock and for electrical lock powering use output screw

„12V output” (7). When is used PoE then 12V/300mA is available.

CAUTION: There must not be activated both electrical locks simultaneously.

It might be reached for example by relays synchronization and setup progressive door opening (setting is descriped in follow capture relays setting)

1.4.4 Usage of door contacts

The door sensors might be connected max. 2 to door entry IP BOLD.

There are designed for transmission of door close informatik. This information is display on initial screen (under picture from camera). It is also transmit to iBell office applications. Further posibility is use SNMP.

The door sensor is ether part of electrical lock or it is ordinary magnetic contact used in security. It is connect as button to screw terminal (13), eventually to screw terminal (18). Those screw terminals are designed for buttons connection. Door sensors connection allways require special button module with cable for door sensors connection. This feature is optional. Therefore you have to order in advance.

IP BOLD - installation and operating instructions 19

20 IP BOLD - installation and operating instructions