advertisement
1.5.3 Open and close of cover
Cover opening
Bottom lath is connected to alu profile by 2 internal sixedge screws
(1) Screw up to middle way by enclosed key those screws
(2) turn bottom lath to left without its complete taking
(3) slide out name card plexi
Cover closing
Slide name plexi under lath
Turn bottom lath to right to groove reach screw. Screw down the screw.
▪ When you slide name plexi be aware to dont demage seal ruber in grooves
▪ When you install next device please dont forget that name plexi is slide out in down direction. Dont install any other device closely under the unit
▪ Do not seal up the unit in any case! Condenseth water must flow away.
General recomendation for connection
To dont demage the unit please use enclosed screw driver.
Pay attention:
• dont put cable under lighting diod to disturb name cards lifting
• dont squeeze cable under setting block on back side of unit
26 IP BOLD - installation and operating instructions
advertisement
Related manuals
advertisement