advertisement
Picture in Picture
Picture in Picture (PIP)
The concurrent display of two different images is referred to as Picture in Picture.
➠
The coloured buttons do not work as described below for TV sets with
MHEG-5 Software, but they operate as described on page 33 (Digital
Teletext).
➠
A concurrent display of two HDTV signals is not possible.
➠
A concurrent display of two coded stations is not possible.
➠ Picture change and station selection is restricted during recording.
➠
In sets without Digital Recorder DR+, the PIP mode is restricted to AV-PIP
(one TV station and one AV source). If a satellite tuner is upgraded in these sets, PIP mode from digital satellite picture and analogue picture via cable TV or house antenna is possible additionally.
Your TV set distinguishes between two PIP displays:
Split Screen In this case screen is divided in the middle and the additonal
PIP image is shown on the right side of the screen. Both images are compressed horizontally and each gets half of the screen.
Small PIP In this case a small PIP image is inserted in the TV picture.
The PIP operation distinguishes between two functionalities:
Standard PIP Stations freely selectable and changeable for PIP and TV picture (coloured buttons have PIP-specific meaning, see below).
iPIP Only in sets with Digital Recorder: The TV picture is moved to the PIP picture when you press the PIP button. The station of the TV picture is now freely selectable. When you press the PIP button again, the PIP picture returns to the TV picture and the PIP window closes.
Start and end picture in picture mode
Show/hide PIP.
In the Standard PIP function a green frame indicates that the station selection acts on the PIP picture. A white frame means that the operation refers to the main picture. If the frame is blue, the station play is active in the PIP picture. If the iPIP function is activated, this is indicated by an orange frame.
➠
For TV sets with MHEG-5 Software, you switch from the green bar/frame to the white by using the PIP key.
The next time you press the PIP key, PIP is switched off.
Standard PIP operation:
PIP as freeze picture
➠ The frame is green, if not, press the green button.
Red button: Freeze picture in PIP on / off.
- 28
Swap contents of PIP and main picture
➠
The frame is green, if not, press the green button.
Yellow button: swaps contents of TV picture and PIP picture.
Select the PIP picture
➠
The frame is green, if not, press the green button.
Select the station as usual.
2 ZDF
17.00 - 18.30 Flora & Fauna
Select the station for the main picture
➠ The frame is white, if not, press the green button.
Select the station as usual.
1 ARD
17.30 - 20.00 Toskana
Scan station in the PIP
➠ The frame is green, if not, press the green button.
Blue button: Start Scan stations.
The frame turns blue, the stations now change automatically.
Blue button: Stop Scan stations.
The frame is green again.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Remote control – TV functions
- 4 Control unit front side of the device
- 5 Connections rear side of the device – Connect
- 6 Connections rear side of the device – Connect 37 / Connect
- 7 Welcome
- 7 Scope of delivery
- 7 About this operating manual
- 7 TV set equipment
- 7 Trademarks
- 7 Acknowledgements
- 8 Operating convenience with wizards
- 8 The wizards in overview
- 8 Info display and TV index
- 9 For your safety
- 10 Environmental protection
- 11 Initial installation
- 11 Installing the TV set
- 11 Preparing the remote control unit
- 11 Connecting the TV set
- 12 Turning the set on/off
- 12 First installation wizard
- 14 Positioning/aligning the DVB-T antenna
- 15 Operating convenience
- 15 General information on menu operation
- 15 The info display
- 16 The index in the TV set
- 16 The Assist+ menu
- 17 TV menu – Overview diagram
- 17 Radio menu – Overview diagram
- 18 Daily operation
- 18 Select station
- 19 Select video source
- 20 Adjusting the sound
- 21 Adjusting the picture
- 21 Operation without remote control
- 22 Button functions
- 24 Managing stations
- 24 TV stations
- 27 Put together / change favourites list
- 28 Picture in Picture
- 28 Picture in Picture (PIP)
- 29 Configure Picture in Picture (PIP) mode
- 30 Electronic Programme Guide
- 30 Electronic Programme Guide – EPG
- 31 Configuring EPG
- 32 Teletext
- 33 Teletext menu
- 33 Digital teletext (MHEG-5)
- 34 Conditional Access module (CA module)
- 35 Software update
- 36 Radio
- 36 Radio mode
- 36 EPG – Electronic Programme Guide (radio)
- 37 Operating additional equipment
- 37 Device connection wizard
- 39 Connecting devices to the HDMI (DVI) connections and playback
- 39 Connecting devices to the PC IN connection and playback
- 40 Connecting devices to the Component IN connection and playback
- 41 Sound components wizard
- 41 Play sound via active speakers
- 41 Play sound via TV speakers and active subwoofer
- 42 Connecting audio amplifiers
- 43 Assignment of the digital audio input
- 43 Audio connection in HDMI (DVI) devices
- 43 RS-232C interface (upgradable interface)
- 44 The direct way to record
- 45 Timer recording with external devices
- 46 PhotoViewer
- 48 MusicBox
- 52 Operating Loewe equipment
- 54 Rotating the TV set (upgradable interface)
- 55 Troubleshooting
- 57 Technical data
- 57 General data
- 57 Electrical data
- 57 Connections (max. equipment)
- 58 Accessories
- 58 Setup possibilities
- 58 Accessories
- 59 Equipment variants and upgrade kits
- 60 Glossary
- 63 Index
- 64 Service