advertisement
MGate MB3000 Modbus Gateway Configuring the Modbus Gateway
You can check the Enable Offline Open status from the Offline Open column.
Configure IP Address and Other Network Settings
The Network tab is where the unit’s network settings are configured. You can modify the Name, Network
Configuration, IP Address, Netmask, Default Gateway, and DNS. You may also select a Password to protect the unit from unauthorized access.
Parameter
Name
Network
Configuration
IP Address
Value
(an alphanumeric string)
Static IP, DHCP, BootP, or
DHCP/BootP
192.168.127.254
(or other 32-bit number)
Notes
You can enter a name to help you identify the unit, such as the location, function, etc.
Select “Static IP” if you are using a fixed IP address.
Select one of the other options if the IP address is set dynamically.
The IP (Internet Protocol) address identifies the server on the TCP/IP network.
9-14
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 6 Seamless integration of Ethernet and serial Modbus devices
- 6 Powerful operation modes to handle almost any Modbus application
- 6 Windows utilities for easy setup and traffic monitoring
- 9 RS-485 Termination and Pull High/Low Resistors
- 10 Connecting to a Host or the Network
- 10 Installing the Software
- 10 Mounting the Unit
- 15 DB9 (Male)
- 21 DB9 (Male)
- 33 Terminal Block (RS-422, RS-485)
- 34 Power Input, Relay Output
- 40 DB9 (Male)
- 40 Power Input, Relay Output
- 43 Connect all Modbus devices over an Ethernet network
- 43 Link a serial master device with Ethernet slave devices
- 44 Link TCP master devices with both ASCII and RTU serial devices simultaneously
- 44 Let Modbus serial devices communicate over the Internet
- 50 Change Language Setting
- 51 Broadcast Search
- 52 Specify IP Address
- 54 Configure Serial Port for RTU or ASCII, Master or Slave
- 55 What is ProCOM?
- 55 How to Configure ProCOM for the MGate MB3000
- 57 Offline Open
- 58 Configure IP Address and Other Network Settings
- 59 Configure Serial Communication Parameters
- 60 RTS Toggle
- 61 Set Up Slave ID Mapping (Smart Routing)
- 61 How Slave IDs are Mapped on the MGate MB3000
- 62 How Slave ID Map is Defined
- 62 Slave ID Map Example
- 62 Customize Modbus Settings
- 63 Initial Delay
- 63 Modbus TCP Exception
- 63 Slave Channel and Response Timeout
- 63 Inter-Character Timeout
- 63 Inter-Frame Delay
- 65 Set Up Priority Control
- 66 Accessible IP
- 67 SNMP
- 68 Miscellaneous Setup
- 71 Open Traffic Monitor Window
- 72 Filter Traffic Information
- 73 Save Log to File
- 75 MXview for the MGate MB3000 Series
- 83 Normal
- 84 Exception
- 84 Broadcast
- 84 Response Timeout