advertisement
Motion detection
“Enable motion detection” Check this option to turn on motion detection.
Click on this button to add a new window. At most three windows can exist simultaneously. Use the mouse to click, hold, and drag the window frame to resize or the title bar to move. Clicking on the ‘x’ at the upper right-hand corner of the window to delete the window. Remember to save in order to validate the changes.
Click on this button to save the related window settings. A graphic bar will rise or fall depending on the image variation. A green bar means the image variation is under monitoring level and a red bar means the image variation is over monitoring level.
When the bar goes red, the detected window will also be outlined in red. Going back to the homepage, the monitored window is hidden but the red frame shows when motion is detected.
"Window Name" The text will show at the top of the window.
“Sensitivity” This sets the endurable difference between two sequential images.
“Percentage” This sets the space ratio of moving objects in the monitoring window.
Higher sensitivity and small percentage will allow easier motion detection.
The following figure shows the screen when is clicked. The monitoring window has been outlined in red and the graphic bar goes red since the goldfish is moving.
- 42 -
advertisement
Related manuals
advertisement
Table of contents
- 3 Before You Use This Product
- 7 Package Content
- 8 Installation
- 8 Hardware installation
- 9 Software installation
- 9 Initial Access to the IP Camera
- 9 Check Network Settings
- 10 Add Password to prevent Unauthorized Access
- 10 How to Use
- 10 Authentication
- 11 Installing plug-in
- 13 Primary user’s capability
- 13 Main Screen with Camera View
- 14 Digital Zoom
- 14 Snapshot
- 15 Client settings
- 17 Digital output
- 17 Administrator’s capability
- 17 Fine-tuning for Best Performance
- 20 Opening accounts for new users
- 22 Build a security application
- 23 Software revision upgrade
- 24 Definitions in Configuration
- 26 System parameters
- 27 Security settings
- 28 Network settings
- 28 Network type
- 29 RTSP Streaming
- 33 Access List
- 34 Audio and Video
- 34 Video Settings
- 34 Video orientation
- 34 Audio settings
- 37 Image Settings
- 39 Email & FTP
- 39 Email
- 42 Motion detection
- 43 Application settings
- 43 Application
- 43 Snapshot
- 44 Weekly schedule
- 44 Snapshot file name prefix
- 44 Digital input
- 44 Send out the snapshot while motion detection
- 44 Sequential operation
- 45 Method for sending snapshot
- 47 Video clip
- 47 Weekly schedule
- 47 Video clip file name prefix
- 47 Video clip max file size
- 47 Digital input
- 47 Send out the video clip while motion detection
- 48 Sequential operation
- 48 Method for sending snapshot
- 50 Digital output
- 50 Weekly schedule
- 50 Digital input
- 50 Trigger digital output while motion detection
- 52 System log
- 53 Viewing system parameters
- 55 Maintenance
- 56 Appendix
- 56 A. Troubleshooting
- 56 Status LED
- 56 Reset and restore
- 57 B. URL commands of the IP Camera
- 57 Get server parameter values
- 58 Set server parameter values
- 59 Available parameters on the server
- 69 Application page CGI command
- 71 Capture single snapshot
- 71 Account management
- 72 System logs
- 73 Configuration file
- 73 Upgrade firmware
- 75 C. Technical specifications