advertisement
▼
Scroll to page 2
of
77
Application settings
Application
Application has two snapshot, one video clip and one digital output.
“Status” ON/OFF show the status of application.
“Sun” ~ “Sat” Select the days of the week to perform the application.
“Time” show “Always” or input the time interval.
“Trigger” Event trigger type has digital input, motion detection and sequential.
“Send” After Event has been triggered, IP cam will send something by email, ftp or trigger digital output.
Snapshot
“Enable snapshot” Enable/Disable snapshot application.
- 43 -
advertisement
Related manuals
advertisement
Table of contents
- 3 Before You Use This Product
- 7 Package Content
- 8 Installation
- 8 Hardware installation
- 9 Software installation
- 9 Initial Access to the IP Camera
- 9 Check Network Settings
- 10 Add Password to prevent Unauthorized Access
- 10 How to Use
- 10 Authentication
- 11 Installing plug-in
- 13 Primary user’s capability
- 13 Main Screen with Camera View
- 14 Digital Zoom
- 14 Snapshot
- 15 Client settings
- 17 Digital output
- 17 Administrator’s capability
- 17 Fine-tuning for Best Performance
- 20 Opening accounts for new users
- 22 Build a security application
- 23 Software revision upgrade
- 24 Definitions in Configuration
- 26 System parameters
- 27 Security settings
- 28 Network settings
- 28 Network type
- 29 RTSP Streaming
- 33 Access List
- 34 Audio and Video
- 34 Video Settings
- 34 Video orientation
- 34 Audio settings
- 37 Image Settings
- 39 Email & FTP
- 39 Email
- 42 Motion detection
- 43 Application settings
- 43 Application
- 43 Snapshot
- 44 Weekly schedule
- 44 Snapshot file name prefix
- 44 Digital input
- 44 Send out the snapshot while motion detection
- 44 Sequential operation
- 45 Method for sending snapshot
- 47 Video clip
- 47 Weekly schedule
- 47 Video clip file name prefix
- 47 Video clip max file size
- 47 Digital input
- 47 Send out the video clip while motion detection
- 48 Sequential operation
- 48 Method for sending snapshot
- 50 Digital output
- 50 Weekly schedule
- 50 Digital input
- 50 Trigger digital output while motion detection
- 52 System log
- 53 Viewing system parameters
- 55 Maintenance
- 56 Appendix
- 56 A. Troubleshooting
- 56 Status LED
- 56 Reset and restore
- 57 B. URL commands of the IP Camera
- 57 Get server parameter values
- 58 Set server parameter values
- 59 Available parameters on the server
- 69 Application page CGI command
- 71 Capture single snapshot
- 71 Account management
- 72 System logs
- 73 Configuration file
- 73 Upgrade firmware
- 75 C. Technical specifications