VSP600 Configuration Methods. VTech VSP600, ErisTerminalVSP600, VSP601

VSP600 Administrator and Provisioning Manual

VSP600 Configuration Methods

You can configure the VSP600 using one of the following methods:

 From the VSP601 handset, using the handset menus. The VSP601 menus are best suited to configuring a few settings, perhaps after the initial setup has been done. For administrators, the settings available on the VSP601 menus include

network settings, account settings, and provisioning settings. See

“Using the

Admin Settings Menu” on page 18

. Most of the settings accessible on the

VSP601are most useful for end users. Through the menu, they can customize the screen appearance, sounds, and manage calls. For more information, see the

VSP600/VSP601 User Guide.

 The Web User Interface, or WebUI, which you access using your Internet browser.

See

“Using the WebUI” on page 24

. The browser-based interface is easy to

navigate and best-suited to configuring a large number of VSP600 settings at once.

The WebUI gives you access to every setting required for configuring a single device. You can enter service provider account settings on the WebUI, assign accounts to handsets, and set up provisioning, which will allow you to automatically and remotely update the VSP600 after initial configuration.

 Provisioning using configuration files. Working with configuration files allows you to configure the device at regular intervals. There are several methods available to enable the VSP600 to locate and upload the configuration file. For example, you can enable the VSP600, when it starts up or reboots, to check for the presence of a configuration file on a provisioning server. If the configuration file is new or has been modified in any way, the VSP600 automatically downloads the file and

applies the new settings. For more information, see

“Provisioning Using

Configuration Files” on page 69

.

Introducing the VSP600 13

Back to Contents