advertisement
SM CS Series Heat
Unit Check-Out Sheet | 19
UNIT CHECK-OUT SHEET
Customer Data
Customer Name _____________________________________________
Address ______________________________________________________
_______________________________________________________________
Phone _______________________________________________________
Date ___________________________________
Unit Number ___________________________
Unit Nameplate Data
Unit Make _________________________________________
Model Number ____________________________________ Serial Number ____________________________________
Refrigerant Charge (oz) __________________________
Compressor: RLA ____________________ LRA ___________________________
Blower Motor: FLA (or NPA) ___________ HP ____________________________
Maximum Fuse Size (Amps) ____________
Maximum Circuit Ampacity _____________
Operating Conditions
Entering / Leaving Air Temp
Entering Air Measured at:
Leaving Air Measured at:
Entering / Leaving Fluid Temp
Fluid Flow (gpm)
Compressor Volts / Amps
Blower Motor Volts / Amps
Source Fluid Type
Fluid Flow (gpm)*
Fluid Side Pressure Drop*
Suction / Discharge Pressure (psig)*
Suction / Discharge Temp*
Suction Superheat*
Entering TXV / Cap Tube Temp*
Liquid Subcooling*
* Required for Troubleshooting ONLY
Cooling Mode
_______________ / _____________
______________________________
______________________________
_______________ / _____________
______________________________
_______________ / _____________
_______________ / _____________
______________________________
______________________________
______________________________
_______________ / _____________
_______________ / _____________
______________________________
______________________________
______________________________
Heating Mode
_______________ / _____________
______________________________
______________________________
_______________ / _____________
______________________________
_______________ / _____________
_______________ / _____________
______________________________
______________________________
______________________________
_______________ / _____________
_______________ / _____________
______________________________
______________________________
______________________________
Auxiliary Heat
Unit Make __________________________________
Model Number: ______________________________ Serial Number _____________________________
Max Fuse Size (Amps) _______________________
Volts / Amps _______________________________
Entering Air Temperature _____________________
Leaving Air Temperature ______________________
MAIL TO:
[email protected] or scan the QR code and attach picture of this form with the information requested.
Bosch Group
601 NW 65th Court
Fort Lauderdale, FL 33309
Phone: (866) 642-3198
Fax: (800) 776-5529
Revised 01-15 8 733 920 846 (2015/01)
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Model Nomenclature
- 3 Key to Symbols
- 3 Safety Warnings
- 4 Standard SM CS package
- 4 GENERAL DESCRIPTION
- 4 MOVING AND STORAGE
- 4 INITIAL INSPECTION
- 4 LOCATION
- 4 Condensing Section
- 5 Air Handler
- 5 PIPING
- 6 ELECTRICAL
- 6 Safety Devices and the UPM Controller
- 10 OPTIONS
- 10 Heat Recovery Package (HRP)
- 10 DPS Water Flow Proving
- 10 Pump Relay
- 10 Comfort Alert Module
- 11 HEAT RECOVERY PACKAGE
- 11 Water Tank Preparation
- 11 HR Water Piping
- 12 Water Tank Refill
- 12 Initial Start-Up
- 13 SEQUENCE OF OPERATION
- 13 Cooling Mode
- 13 Heating Mode
- 15 APPLICATION CONSIDERATIONS
- 15 Well Water Systems
- 16 Cooling Tower/Boiler Systems
- 18 Geothermal Systems
- 19 SYSTEM CHECKOUT
- 19 UNIT START-UP
- 20 MAINTENANCE
- 21 UNIT CHECK-OUT SHEET
- 22 TROUBLESHOOTING
- 25 Unit Lockouts
- 26 OPERATING TEMPERATURES AND PRESSURES
- 31 WATER SIDE PRESSURE DROP TABLE
- 32 WIRING DIAGRAMS
- 33 DIMENSIONAL DRAWINGS
- 34 SPARE PARTS LIST
- 35 CS Parts List - Cabinet
- 36 CS Parts List -Refrigeration/Electrical
- 39 Notes