Device Configuration Menu. Lowrance LCX-38C HD, LCX-113C HD, LCX-112C, LCX-28C HD

8. Repeat Steps 5-7 for each remaining tank.

9. When all tanks have been configured, press the

S

ET

C

ONFIGURATION

button. The following confirmation message will appear: Are you sure

you wish to change the bus configuration? Choose

Y

ES

and press

ENT

,

Press

EXIT

to get back to the main display.

Device Configuration Menu

When a device is selected from the network devices list on the Bus

Configuration menu, its Device Configuration menu will appear. Device configuration menus vary among devices. Available functions on device configuration menus allow you to change device names, tank sizes, fluid types and provide access to the Advanced Options menu. We will cover configuration and calibration later in this section.

Device Information and Device Data

The Device information panel, located to the left of the Device Configuration menu, displays information on the selected device that includes, software version, model, address, serial number, instance and current status.

If you do not have an EP-15 Fluid Level, EP-10 Fuel Flow or EP-20

Engine Interface on the network, the Bus Configuration menu will not display the Engine-Tank Configuration menu, Tank Select menu, Tank

Size menu or Set Configuration button.

Device Data is shown in the Device Data window at the bottom of the device configuration menu. The information displayed in the Device Data window will vary among devices. If, for example, you are viewing the device configuration menu for an EP-15 Fluid Level, the device data window will include tank size and the amount of fuel left in the tank. The Device Data for an EP-10 Fuel Flow includes Fuel Rate (amount of fuel burned per hour), Fuel

Used, Trip Fuel Used and Seasonal Fuel Used.

NOTE:

If, as in the graphic above, you do not have a Suzuki Engine Interface, EP-

15 Fluid Level or EP-10 Fuel Flow on the network, the Engine &

Configuration menu, Tank Select menu, Tank Size dialog and Set

Configuration button will not be displayed on the Bus Configuration menu.

190