Advanced Options menu. Lowrance LCX-38C HD, LCX-113C HD, LCX-112C, LCX-28C HD

4. Press ↓ to

F

LUID

T

YPE

and press

ENT

, which will open the Fluid Type menu with the following options: Fuel, Water, Gray Water, Live Well,

Oil, Black Water and Unknown.

5. Select the desired fluid type and press

ENT

. The following message will appear: Are you sure you wish to change this device's configuration?

6. Highlight

Y

ES

and press

ENT

. Press

EXIT

repeatedly to get back to the main display.

To input Tank Size:

1. Press

MENU| MENU

, use

↑ ↓ to select

NMEA 2000

and press

ENT

. The

NMEA 2000 menu will appear with five options: Bus Setup, Fuel

Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight

Synchronization.

2. Highlight

B

US

S

ETUP

and press

ENT

, which will open the Bus Configuration menu. A list of network devices will be at the top of the page.

3. Select the desired fluid level and press

ENT

. The Fluid Level Device

Configuration menu will appear.

4. Highlight

T

ANK

S

IZE

and press

ENT

. Use ↑ ↓ ,← → to input the size of the tank and press Enter. The following message will appear: Are you

sure you wish to change this device's configuration?

5. Select

Y

ES

and press

ENT

. Press

EXIT

repeatedly to get back to the main display.

Advanced Options menu

The Fuel Flow sensor Advanced Options menu contains two categories:

Instance and Restore Defaults.

Instance

The Instance command is intended for use only by experienced NMEA

2000 network technicians. Instance allows network technicians to resolve certain electronic probe conflicts. This is most likely to occur if the network includes LMF-200 or LMF-400 digital gauges, which support the display of fewer electronic probes than your GPS or sonar/GPS unit. If you want to use your unit in a network including one of these digital gauges, you may need to consult customer service.

You should never need this command if you are connecting your unit to a network with similar display units and/or a series of electronic probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-15

Fluid Level Sensor's settings to factory defaults. If, for example, you execute the Restore Defaults command from your Gray Water Fluid

Level Advanced Options menu, only the settings for the Gray Water

Fluid Level will be reset to factory defaults. Other fluid levels on the network will not be affected.

199