Scotts TC70105S 11 in. 10.5-Amp Corded Electric Tiller/Cultivator Replacement Part List
Add to My manuals2 Pages
advertisement
Model: TC70105S
Power supply voltage:
Tine Speed:
Power Consumption:
1
PRODUCT SPECIFICATIONS
120V-60HZ
350 RPM
10.5 Amp
Working width:
Working depth max:
7-IN or 11-IN
8-IN
No. Description
1 Upper handle section
2
3
Bail wire
Switch box and power cable assembly
4
5
Cable clip
Cord retainer
No. Description
11 Wheel hub cap
12 Wheel frame lock pin
13 Motor housing
14 Protective shield
15 Tine assembly, D
6
7
8
Wing nut
J-bolt M6
Center handle section
16 Tine assembly, C
17 Tine assembly, B
18 Tine assembly, A
9 Lower handle section - II 19 Tine lock pin
10 Lower handle section - I 20 Wheel
4
Model TC70105S
ASSEMBLY
This product must be assembled correctly before use.
1. Remove the screws (M5 X 12) and washers from 4. Slide the cord retainer onto the center handle each end of the wheel frame axle. Assemble the section. (Fig. 2-3) wheels onto the axle, then install washers and 5. Attach the center handle section to the lower handle screws (M5 X 12) to secure. (Fig. 2-1) sections using the two supplied M6 J-bolts and wing
2. Press the hub caps into the wheels and cover the nuts. (Fig. 2-4) ends of the axles. You may use a hammer to seat 6. Fasten the upper handle section to the center handle them securely into the wheels. (Fig. 2-1) section using the two supplied M6 J-bolts and wing
3. To lower wheel frame, push the lock button on back nuts .
(Fig. 2-5) of motor housing to release the frame (Step A). 7. Use the two supplied cable clips to secure the cord to
advertisement
Related manuals
advertisement