Covenant Security Equipment CSE-QS-QST-625S-L1 CSE-QS-QST-625S Installation Instructions

STEPS AND PROCEDURE

1) Slide Drawer through rough opening from the interior side to the exterior.

2) Attach flange to outside of the drawer using the 4 each screws supplied to the pre-tapped holes on the side of the drawer.

3) Slide drawer flush with exterior wall.

4) Anchor bottom of drawer to counter top or shelf.

5) Maximum mullion width (depth) above drawer to be no more than 4-1/2" for maximum transfer area (ITEM 1)

6) Back panel of the drawer must be accessible for service.

1

1

COUNTER

OR

SHELF

Rough Opening

24-5/8"(W) x 6-5/8"(H)

Drawer must be installed level & square to work properly.

9323 N Government Way

Hayden, ID 83835

NOTE: THIS DRAWING EMBODIES A CONFIDENTIAL PROPRIETY DESIGN ORIGINATED AND OWNED BY COVENANT SECURITY EQUIPMENT

SUBMITTED UNDER A CONFIDENTIAL RELATIONS ALL PATENT, MANUFACTDURING, SALE RIGHTS REGARDING THE SAME ARE RESERVED EXCEPT

TO THE EXTENT RIGHTS ARE EXPRESSLY GRANTED TO OTHERS. THE RECIPIENT AGREES BY ACCEPTING HIP. THESE DRAWINGS NOT TO SUPPLY OR

DISCLOSE ANY INFORMATION REGARDING THEM TO ANY UNAUTHORIZED PERSON.

DRAWING NAME:

CSE-QS-QST-625S INSTALLATION