The T 6 P, T 12 P, and T 20 P Drying Ovens are designed for laboratory use. They can be used for various applications such as drying, ageing, analysis, fusing, burning in, oxidizing, reducing, preheating, and hot-air sterilization. The ovens are equipped with a programmed controller and can be set to operate at temperatures between room temperature + approx. 10°C and 250 °C. The ovens are also designed for continuous use and feature an independent overtemperature protection device, which means they do not require constant supervision.
Advertisement
Advertisement
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
Advertisement
Temperature Range: Room temperature + 10°C to 250°C
Programmable temperature control
Independent overtemperature protection
Continuous use
Hot-air sterilization capability
Time-switch function
Fixed program segments
Programmed controller function
No, the oven cannot be used to dry or heat substances that may release combustible gases or vapors into the atmosphere. It is also unsuitable for the heat treatment of combustible dusts or fibrous materials.
You must use a draft breaker to connect the oven to an extraction system. All flue ducts must be made of fireproof materials and thermally insulated.
The oven is equipped with an electronic upper-limit cut-out device (TWB) of protection class 2 as defined by DIN 12 880 Part 1. It is electrically and functionally independent of the temperature control system. If the unit heating system malfunctions, the TWB will shut down the unit heating across all poles as soon as the temperature exceeds the preset value.
The fixed program contains a maximum of four program segments and a status command. Each program segment is assigned to a typical temperature / time response. 10 selectable sets of parameters are permanently stored in the database for each program segment.
The programmed controller function enables the arbitrary definition of temperature / time processes. You may select up to 9 program segments. Operating temperature and period can be selected for each segment.
Where can I find the electrical schematic for the T6P oven?
The electrical schematic for the T6P oven is available as an approved spare part or accessory. You can locate the order numbers for the circuit diagrams in the 'Approved spare parts / accessories' section of the manual. For 1/PE AC, 230 V/208V, the order number is 50 041 987. For 1/PE AC, 120 V, the order number is 50 040 640.
What is the recommended relative humidity for operating the device?
The recommended relative humidity for operation is between 60 and 70%, avoiding condensation. The maximum relative humidity is 80% for temperatures up to 31°C, decreasing linearly to 50% relative humidity at 40°C.
