advertisement
Safety Notes
- Installation and Maintenance of the System only by trained personnel.
- Important! To prevent personal injury and damage to equipment please ensure that the system is properly earthed and that the appropriate cable is connected in the mains plug.
- The System must be installed horizontal so that the connection panel is on the right hand side.
- Do not connect or disconnect any PSTN lines during a thunderstorm.
- Install lines and extensions in such a way that no one walks or trips over them.
- Disconnect the System from the mains supply before opening the connection panel.
Before connection of lines and extensions please ensure that the system is unplugged from the mains supply. DANGER!
- Preventive measure! Before carrying out any installation work, please touch briefly the
PC/Printer socket of the telephone system. This will discharge any possible electrostatic charges, thus protecting the telephone system’s electrostatically sensitive components.
- Do not allow liquids to enter the system as short-curcuits may occur.
- No liability will be accepted for consequential damages such as an unintentional continued connection of a line.
- The telephone system will not operate in case of power failure and you will not be able to make any type of call.
The telephone system is intended for connection to an ISDN basic rate access (DSS 1). You may also connect any type of analogue telephone to the system which has been approved for connection to the Public Switched Telephone Network (PSTN). You may also connect all
DSS 1 ISDN terminals to an internal S0 bus that has been approved for direct connection to the ISDN network.
Doorphones must conform to the specification of the respective interface. Any other use of the system is not permitted and therefore illegal
The telephone system has a general connection permit (Germany: AAE).
The telephone system conforms to the prescribed conformity and safety regulations.
About this User Manual
The instruction is valid for the default setting of the system. If the system should be modified due to software made available through the manufacturer then it may be possible that sections of the instruction manual become invalid. All listed ISDN features will be supported by the system. However, some features may not be available through the
Network Operator.
advertisement
Related manuals
advertisement
Table of contents
- 2 Safety Notes
- 2 About this User Manual
- 3 Table of contents
- 7 CTI - computer telephony integration
- 8 System telephones
- 11 System Telephone ST 20/ ST 25
- 12 System Telephone ST 30
- 13 Setting up and cleaning the system telephones
- 13 Cleaning
- 14 DECT 30 System Cordless Phone
- 22 Overview of freely programmable Function Buttons
- 37 Call Waiting / Callback when free
- 40 Call Pick Up
- 41 Call Log
- 41 Call Log on/off
- 44 Switching between Day and Night Service
- 49 Announcement (Paging)
- 51 Voice Message
- 55 Remote Dial Functions
- 56 Malicious Call Identification (MCID)
- 57 Conference
- 60 Least Cost Routing (LCR)
- 60 Switching Least Cost Routing on/off
- 66 Switching Relays
- 82 Timer functions
- 100 World Clock
- 107 External Line Access
- 114 Call waiting / Call Back when free
- 116 Call Waiting
- 117 Do Not Disturb
- 118 Switching between Day and Night Sevice
- 120 Announcement
- 128 Least Cost Routing (LCR)
- 131 Switching Relays
- 150 Display Call Charges on an analogue phone
- 151 CLIP - display caller's phone number
- 152 Groups
- 153 Callthrough
- 158 Programming from the system telephone or a/b telephone
- 166 Maintenance/ Testing
- 171 Downloading new software
- 173 Advanced Users Programming
- 174 Programming tree
- 178 Glossary
- 188 Appendix
- 189 Tones
- 190 Index
- 194 Declaration of Conformity
- 190 A
- 2 About this User Manual
- 33 Accepting Incoming Calls
- 160 Adjusting the flash time
- 173 Advanced Users Programmin
- 76 Alphabetic
- 190 Amtsleitung. Siehe Wählleitung
- 49 Announcement
- 26 Announcement Button
- 190 Anrufen. Siehe Telefonieren
- 190 Anrufweiterschaltung. Siehe Umleitung zu
- 178 Answering station - VST
- 80 Appointment Call
- 49 Auto Dialling
- 121 Auto Dialling (Hotline)
- 55 Automatic Call
- 68 Automatic Call Back
- 55 Automatic Mike
- 98 Automatic Redial
- 190 B
- 190 B-Kanal. Siehe Wählleitung
- 137 Baby call
- 65 Baby Listening
- 129 Baby Listening / Room Monitor
- 190 Babyruf. Siehe Direktruf
- 36 BROKERS CALL
- 50 Busy on Busy
- 15 Button allocation of the DECT 30 System Phone
- 24 Button Assignment
- 25 Button Assignment of Specific Functions
- 190 C
- 22 Call by Call
- 48 Call Deflection
- 25 Call Forwarding
- 46 Call Forwarding (on/off)
- 20 Call Log
- 20 Call Log ON / OFF
- 41 Call Log on/off
- 54 Call on Hold
- 26 Call Pick Up
- 61 Call Split
- 35 Call Transfer
- 36 Call Transfer without announcement
- 33 Call Waiting
- 111 Call waiting
- 114 Call waiting / Call Back
- 37 Call Waiting / Callback when free
- 39 Call Waiting on/off
- 38 Callback
- 30 Calling an external number
- 153 Callthrough
- 130 Cancelling room monitoring
- 63 Carrier Access Code
- 72 Changing a Number in the Phonebook
- 97 Check in / Check out
- 13 Cleaning
- 57 Conference
- 157 Connecting a PC
- 18 Cost display
- 7 CTI - computer telephony integratio
- 7 CTI - computer telephony integration
- 55 CTI Dialling
- 190 D
- 44 Day and Night Service
- 185 Deactivating the special dial tone
- 14 DECT 30 System Cordless Phone
- 73 Deleting a Number from the phonebook
- 74 Dialling Numbers from the Phone Book
- 137 Direct call
- 78 Direct Call (Baby Call)
- 92 Display and delete call charges
- 150 Display Call Charges on an analogue phone
- 87 Diversion from
- 88 Diversion to
- 43 Do Not Disturb
- 25 Do not disturb
- 83 Door Call Variant
- 85 Door opener
- 28 Door Phone and Lock Release
- 85 Doorphone
- 84 Doorphone Diversion
- 141 Doorphone Night Service
- 171 Downloading new software
- 190 E
- 79 Emergency Call
- 67 Enquiry
- 163 enter Codes
- 73 Entering an Emergency Number
- 98 Extended redial
- 69 Extension Status
- 109 External Acces with specific MSN
- 31 External Access with MSN Button
- 31 External Access with special MSN Button
- 21 External Line Access
- 36 External Transfer
- 190 Externbelegung. Siehe Amtsholung
- 190 F
- 190 Follow me. Siehe Umleitung von
- 190 G
- 190 Gebühren. Siehe Verbindungskosten
- 26 Group Button
- 103 Groups
- 191 H
- 17 Handsfree Microphone - Set to Auto on
- 22 Headset
- 191 I
- 5 Important notes on using analogue equipment
- 6 Important notes on using ISDN terminals
- 13 Insertion of label strips for function buttons
- 27 Intercom (Specific Extension)
- 120 Internal Call Forwarding on / off
- 113 Internal Transfer
- 35 Internal Transfer with announcement
- 191 K
- 191 Kurzwahl. Siehe Telefonbuch
- 191 L
- 60 Least Cost Routing
- 128 Least Cost Routing (LCR)
- 152 Log In / Log Out
- 191 M
- 166 Maintenance/ Testing
- 30 Make a Call Spontaneous seizure with internal
- 29 Making a Call
- 56 Malicious Call Identification (MCID)
- 191 Montage. Siehe Installation
- 27 MSN CO Button
- 191 N
- 25 Night Service
- 44 Night Service on/ off
- 159 Notes on programming with S- procedures
- 134 Numeric retrieval
- 191 O
- 142 Operating the Doorphone and Door opener
- 22 Overview of freely programmable Function Buttons
- 191 P
- 64 Parking a Call
- 71 Phonebook
- 191 Pick up. Siehe Anrufe heranholen
- 8 Pictograms and Buttons
- 8 Piktogramme
- 70 Pop Up Menu
- 185 Power Failure
- 93 Printing of Metered Call Charges
- 158 Programming from the system telephone
- 173 Programming tree
- 157 Programming via PC
- 191 R
- 97 Record Call Charges for Extensions (Start / Stop)
- 48 Reject a call
- 28 Relay
- 26 Remote Answering
- 55 Remote Dial Functions
- 169 Remote setting - Remote configuration
- 114 Request Ringback
- 37 Requesting Ring back when free
- 31 Reserving an Outside Line
- 109 Reserving an outside line
- 168 Reset the System
- 161 ringer rhythm
- 188 Rings
- 65 Room Monitor
- 191 Rufweiterschaltung intern. Siehe Anrufvariante 3
- 191 Ruhe vor dem Telefon. Siehe Anrufschutz
- 191 S
- 2 Safety Notes
- 69 Scrolling through Display Messages
- 86 Sending CLIP or COLP
- 155 Sensor Input
- 19 Set Date & Time
- 20 Set Language
- 107 Setting External Seizure
- 17 Setting the Display Contrast
- 17 Setting the Headset Volume
- 16 Setting the Ringers Tone or Pitch
- 16 Setting the Ringing volume
- 17 Setting the Speaker Volume
- 13 Setting up and cleaning the system telephones
- 101 Single Button Dialling
- 187 Software reset
- 191 Spontane Amtsholung. Siehe Automatische Amtsholung
- 109 Spontaneuos Outside Line Seizure
- 159 Starting the programming mode
- 19 Status Display & Date/ Time
- 71 Storing a Number
- 134 Storing and Dialling Phonebook Numbers
- 62 Storing the Last Number
- 118 Switching between Day and Night Sevice
- 140 Switching over the door call variant
- 66 Switching Relays
- 168 System phone registration
- 98 System Redial
- 157 System requirements
- 11 System Telephone ST 25
- 12 System Telephone ST 30
- 8 System telephones
- 16 System Telephones - settings
- 192 T
- 3 Table of contents
- 7 TAPI
- 103 Telephone Answering Machine (TAM)
- 78 Telephone Lock
- 136 Telephone lock
- 18 Telephone Lock (PIN)
- 82 Timer
- 138 Timer Functions
- 124 To place a Call on Hold
- 19 To Set Date & Time
- 189 Tones
- 56 Tracing a Call
- 37 Transfer an Outside Line
- 192 U
- 172 Update Dect Module Firmware
- 192 V
- 76 Vanity
- 51 Voice Message
- 123 Voice MessageAnnouncement
- 192 W
- 99 Wake Up Call
- 192 Weiterverbinden. Siehe Weitergabe
- 186 What to do in the event of malfunctions
- 192 Wochenprofilautomatik. Siehe Timer
- 100 World Clock