advertisement
Analogue and
ISDN-Phones
Display Call Charges on an analogue phone
On an analogue phone, you only can display call charges if the phone has a meter. To display call charges, you must activate communication of the charge pulses for your phone on your phone.
If you have requested the „communication of call charges during and at the end of the connection“feature from your network carrier, your phone continuously displays the call charges during a connection.
You can display the charges of your last connection that are stored in the telephone system at any time. To do this, it suffices if you have requested the „communication of connection charges at the end of the connection“ feature from your network carrier.
Communication of charge pulses on / off
h
Lift receiver
P S52P Z
1 = on
0 = off
Communication of charge pulses
Enter the digit:
Q P ª
Acknowledgement tone
Replace receiver
Display charges of the last connection
h
Lift receiver
P S44 Q
Display charges of the last connection
Acknowledgement tone; wait until the display appears
P ª
Replace receiver
Notes
If you wish to display the charges of the last connection by entering
S44
, please note that your telephone’s totalizer may total up the costs of the last connection.
For technical reasons, the data on the network carrier’s invoice may deviate from the total call cahrges displayed by the telephone system. The charge units counter in the network carrier’s exchange is always binding.
2 - 46
advertisement