advertisement
Programming your
System
Downloading new software
ST 25 ST 30 DECT 30
The AGFEO ISDN telecommunications systemd can be updated to the latest software version without tampering with the telecommunications system hardware. You can download the new software into the telecommunications system via a PC connected to the telecommunications system’s serial RS 232 C interface. If your telecommunications systems has an internal S0 bus, you can also download software via a PC featuring an ISDN card connected to the internal S0 bus.
Your dealer can also remotely download the new software by ISDN into your telecommunications system.
System requirements
- IBM- or compatible PC with hard disk and CD ROM drive
- Pentium II 233 MHz or higher
- at least 64 MB RAM
- Microsoft Windows 98/2000/ME/XP
- RS 232 C-or USB interface
Connect ion via RS 232 C Bus
- Connect the telecommunications system’s RS 232 interface (D-SUB-9 socket) to the
PC’s COM port.
For connection, use the PC cable belonging to the telecommunications system or a oneto-one V.24 extension cable featuring a male and a female connector (mouse or joystick extension cable). It must not be more than 3 m long.
Save Configuration Data
- Start the "TK-Set" configuration program on your PC
- Read all data out of the telecommunications system (F8).
- Save the data on the hard disk or on a diskette.
Update you software
- Unpacked the Firmware Update Files into the "Updates" subdirectory of the TK-Soft directory on your hard disk (eg. "C:\TKSoft\updates").
- Start the "TK-Flash" update program
Refer to the online help for details of how to operate "TK-Flash".
The new software is now loaded into the telecommunications system. You cannot make any telephone calls during the load operation (approximately 5 minutes). You can observe the load process on the PC’s monitor.
- End "TK-Flash".
- Clear the telecommunications system’s memory from the system telephone or from an a/b telephone. (page 3-15)
3 - 17
Programming your
System
Loading the telecommunications system’s system data
ST 25 ST 30 DECT 30
Copy the stored system data back from the PC into the telecommunications system.
The telecommunications system now operates with the new software.
Update Dect Module Firmware
You can Update your DECT Module Firmware by using the Menu System of the ISDN System.
For using the update function the DECT Module needs Firmware 1.1 or higher.
Make sure the number of the Update Server is configured
Start update with:
!
9#
76
!9#
76
AQ9L
76
3 - 18
advertisement