To replace the memoryback-up battery. Casio KL-7000, KL7000

Add to My manuals
81 Pages

advertisement

To replace the memoryback-up battery. Casio KL-7000, KL7000 | Manualzz

To replace the memory back-up battery

Before using the Label Printer for the first time, be sure that you first use the following procedure to install the memory back-up battery that comes with it. Data stored in memory will be lost if you do not load this battery.

1. Switch power off.

2. Use a small phillips head screwdriver to loosen the screw that secures the back-up battery compartment cover in place, and remove the cover.

3. Wipe off the surfaces of a CR2032 battery with a soft dry cloth, and install it with its plus (+) side facing up (so you can see it).

4. Carefully replace the battery compartment cover and secure it in place with the screw.

• You should use the above procedure to replace the memory back-up battery once a year.

To replace the main batteries

1. Switch power off.

• If you are using the AC adaptor to power the unit, you should also unplug the adaptor from the Label Printer.

2. Open the battery compartment cover on the back of the Label Printer by sliding it in the direction indicated by the arrow.

3. Remove all eight of the old batteries.

4. Load a set of eight new batteries into the battery compartment, making sure that their positive (+) and negative (–) ends are facing in the correct directions.

5. Replace the battery compartment cover.

10

advertisement

Related manuals

advertisement

Table of contents