advertisement
Before You Begin
Safety Notes
Personal Safety
Mounting and
Rigging
Power and Wiring
Operation
Expected LED
Lifespan
Read all the following Safety Notes before working with this product. These notes include important information about the installation, usage, and maintenance of this product.
There are no user-serviceable parts in this product. Any reference to servicing in this User Manual applies only to properly certified Chauvet technicians. Do not open the housing or attempt any repairs unless you are certified by Chauvet.
Please refer to all applicable local codes and regulations for proper installation of this product.
· Avoid direct eye exposure to the light source while the product is on.
· Always disconnect this product from its power source before servicing.
· Always connect this product to a grounded circuit to avoid the risk of electrocution.
· Do not touch this product’s housing during operation because it may be very hot.
· This product is for indoor use only! To prevent risk of fire or shock, do not expose this product to rain or moisture.
· CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to warm humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure, allow product to fully acclimate to the surrounding environment before connecting it to power.
· This product weighs 18.5 lbs (8.39 kg). Always ask for help when mounting this product to avoid personal injuries or damage to the product.
· Make sure there are no flammable materials close to this product while it is operating.
· When hanging this product, always secure to a fastening device using a safety cable
(included).
· Always make sure you are connecting this product to the proper voltage in accordance with the specifications in this manual or on the product’s specification label.
· Never connect this product to a dimmer pack or rheostat.
· Never disconnect this product by pulling or tugging on the power cable.
· Do not operate this product if you see damage on the housing, lenses, or cables. Have the damaged parts replaced by an authorized technician at once.
· To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the product from power via breaker or by unplugging it.
· Do not cover the ventilation slots when operating to avoid internal overheating.
· The maximum ambient temperature is 104° F (40° C). Do not operate this product at a higher temperature.
· In case of a serious operating problem, stop using this product immediately!
In the unlikely event that your Chauvet product may require service, contact
Chauvet Technical Support.
LEDs gradually decline in brightness over time, mostly because of heat. Using clustered
LEDs (as present in this fixture) at their fullest intensity significantly reduces the LEDs’ lifespan. Under normal conditions, this lifespan can be 40,000~50,000 hours. If extending this lifespan is vital, lower the operating temperature by improving the ventilation around the product and reducing the ambient temperature to an optimal operating range. In addition, limiting the overall projection intensity may also help to extend the
LEDs’ lifespan.
-2- COLORado™ 2 Zoom Tour User Manual Rev. 01
advertisement