Mounting. Chauvet Colorado 2 Zoom Tour, Colorado

Setup

-8-

Mounting

Orientation

Rigging

Before mounting this product, read and follow the Safety Notes in this manual.

Always mount this product in a safe position and make sure there is adequate room for ventilation, configuration, and maintenance.

Procedure

Product Mounting

Diagram

The COLORado™ 2 Zoom Tour consists of consists of a double-bracketed yoke and the body of the fixture. Chauvet recommends using the following general guidelines when mounting this product:

· When selecting an installation location, consider easy access to this product for operation, programming adjustments, and routine maintenance.

· Make sure to mount this product away from any flammable material as indicated in the

Safety Notes .

· Never mount in places where rain, high humidity, extreme temperature changes, or restricted ventilation may affect the product.

· If hanging this product, make sure that the mounting location can support the product’s

weight. Refer to the Technical Specifications chart for the weight-bearing requirements

of this product.

· When hanging this product, always secure to a fastening device using a safety cable (included).

The COLORado™ 2 Zoom Tour comes with a double-bracketed yoke to which you can attach clamps for hanging. These brackets can also serve as floor stands or wall-mount supports. You must supply your own clamps and make sure the clamps are capable of supporting the weight of this product. You must use at least one mounting point per product.

Overhead Mounting

Clamp

Safety

Cable

Doublebracketed

Yoke

Floor Mounting

COLORado™ 2 Zoom Tour User Manual Rev. 01