advertisement
Setup
3. Setup
AC Power
AC Plug
Power Linking
The COLORado™ 2 Zoom Tour has an auto-ranging power supply that can work with an input voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the specifications in this manual or on the product’s sticker.
To determine the power requirements for the COLORado™ 2 Zoom Tour, refer to the
specification label affixed to the product or the Technical Specifications
in this manual.
Always connect this product to a protected circuit with an appropriate electrical ground to avoid the risk of electrocution or fire.
The listed current rating indicates the maximum current draw during normal operation. For more information, download the document Sizing Circuit Breakers from the Chauvet website: www.chauvetpro.com
.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0% to 100% switch.
The COLORado™ 2 Zoom Tour comes with a power input cord terminated with a Neutrik® powerCON® connector on one end and an Edison plug on the other end (U.S. market). If the power input cord that came with your product has no plug, or if you need to change the
Edison plug, use the table below to wire the new plug.
Connection Wire (US) Wire (Europe) Screw Color
AC Live
AC Neutral
Black
White
Brown
Blue
Yellow or Brass
Silver
AC Ground Green/Yellow Green/Yellow Green
The COLORado™ 2 Zoom Tour supports power linking. You can power link up to 7 products at 120 VAC, thirteen (13) products @ 208 VAC, or 15 products
@ 230 VAC.
This product comes with a power input cord. This product does not come with a power linking cable; however, a power linking cable is available as an option.
-6- COLORado™ 2 Zoom Tour User Manual Rev. 01
advertisement