advertisement
Setup
Your box must receive a signal strength between 49-79 dBuV, preferably above 64 dBuV. If the signal strength is lower the picture quality is more easily affected by bad weather, such as rain, thunder storms, etc. The signal quality should be 1.0E-7BER and the Lock Indicator should display ‘OK’ in order to successfully find channels. See “Checking the signal” on page 16.
2.
When you have finished viewing the Signal Test screen, press BACK to redisplay the System
Settings menu.
Installation Setup
You use the Installation Setup menu to change the following settings:
◆ LNB setup;
◆
◆
Default transponder;
Modem setting;
◆ RF output.
The items on the Installation Setup menu are explained in more detail in the following sections.
To access the Installation Setup menu:
1.
Press iTV on your remote control.
2.
Highlight ‘System Setup’, then press OK.
3.
Highlight ‘System Settings’, then press OK.
4.
Highlight ‘Installation Setup’, then press OK.
The Installation Setup menu displays:
52
Changing the LNB Setup
This is the number of LNBs available in your dish installation. Default values (shown on the image on page 53) are already entered for this setting; under normal circumstances you do not need to change these. If you change your satellite dish installation, you may need to change this setting so that your box can tune to all the satellites available.
To change the LNB Setup:
1.
On the Installation Setup menu, highlight ‘LNB Setup’, then press OK.
Using your Viasat box
advertisement
Related manuals
advertisement