3-2-5 Channel Mode message. Yamaha MX88, MOX6, CP40, MOXF6, MOXF8, CP4, MOX8Synthesizer, MX61, MOX8, MX49

Add to My manuals
74 Pages

advertisement

3-2-5 Channel Mode message. Yamaha MX88, MOX6, CP40, MOXF6, MOXF8, CP4, MOX8Synthesizer, MX61, MOX8, MX49 | Manualzz

MIDI

Table 3:

RPN

MSB LSB

RPN Parameter List

Parameter

Name

000 000 Pitch Bend

Sensitivity

Data Entry

(Range)

MSB

000 - 024 -

LSB

Function

000 001 Fine Tune -64 - +63 -

000 002 Coarse Tune -24 - +24 -

127 127 Null -

Specifies the amount of pitch bend produced in response to pitch bend data in semitone increments.

Adjusts the tuning in cent increments.

Adjusts the tuning in semitone increments.

Voids the RPN and NRPN settings so no tone generator settings are changed when subsequent Data Entry messages are received.

3-2-5 Channel Mode message

All Sounds Off

(Control #120)

Clears all sounds currently sounding on the specified channel.

However, the status of channel messages such as Note On and Hold On is maintained.

Reset All Controllers

(Control #121)

Resets all controllers to their initial values.

However, some controllers are not affected.

All Notes Off (Control

#123)

Clears all notes currently on for the specified channel.

However, if Hold1 or Sostenuto is on, notes will continue sounding until these are turned off.

Omni Mode Off

(Control #124)

Performs the same operation as when an All Notes Off message is received.

The receive channel is set to 1.

Omni Mode On

(Control #125)

Performs the same operation as when an All Notes Off message is received.

Only the receive channel is set to Omni On.

Mono (Control #126) Performs the same operation as when an All Sound Off message is received.

If the 3 rd byte parameter (the parameter that determines the mono number) is 0 - 16, the parts corresponding to those channels are set to Mono.

Poly (Control #127) Performs the same function as when an All Sounds Off message is received.

Sets the corresponding channel to Poly Mode.

3-2-6 Channel After Touch

Messages that let you control the sounds by the pressure you apply to the keys after the initial striking of the keys, over the entire channel.

3-2-7 Polyphonic After Touch

Messages that let you control the sounds by the pressure you apply to the keys after the initial striking of the keys, for each individual key.

71

advertisement

Related manuals

advertisement

Table of contents