INSTALLATION OF AIR FILTER. MCZ SAGAR, MUSA, TOBA, Suite, Club, NIMA

PELLET STOVES

INSTALLATION AND USE MANUAL

3.5. INSTALLATION OF AIR FILTER

Before placing the stove near the wall for connection to the flue pipe and to the electrical mains, install the air filter provided with the stove.

The cylindrical filter is composed of a metallic net and is included with the accessories (along with the glove, hook, instructions, and so on).

The filter must be inserted on the air inlet pipe Ø 5 cm.

To remove it, slightly loosen the screw with the knob on the air inlet, insert the filter matching it with the filter groove with the screw of the knob and then secure it by tightening the knob.

ATTENTION!

Never operate the stove without the air filter. MCZ shall not be held liable for damage to internal components if this instruction is not followed.

Installation/removal of air filter

3.6. OPENING/CLOSING OF ATHOS STOVE DOOR

ATTENTION!

In order for the stove to operate correctly, it is essential that the door be closed completely.

In Suite/Club/Musa stoves the door is opened using the hook on the door which must be lifted by the cool hand supplied (fig.11); whereas for the Sagar/Toba/Nima stoves slide the cool hand onto door hook, lift and pull (fig.12).

Chapter 3 page 35

Fig. 11 - Opening/closing the door

Suite/Club/Musa

Fig.12 - Opening/closing the door

Sagar/Toba/Nima

3.7. MAKING THE ELECTRICAL CONNECTIONS

Connect the supply cable first at the rear of the stove and then to an electrical outlet on the wall.

The main switch located on the rear of the stove should be switched on only when you want to light the stove.

When the stove is not being used, it is advisable to keep it unplugged.

Installation and assembly

Electrical connection of the stove

Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited