6. EMERGENCY PANEL. MCZ SAGAR, MUSA, TOBA, Suite, Club, NIMA

PELLET STOVES

INSTALLATION AND USE MANUAL

6. EMERGENCY PANEL

At the right rear of the stove, there is an emergency panel. It was designed to diagnose any operating anomalies. It is also used to control the stove if the remote control is not working.

Chapter 4 page 43

KEY

A. Three figure display which indicates a series of information about the stove, as well as the identification code for any operating anomaly.

B. GREEN LED to indicate:

 OFF = Stove off

 FLASHING = Stove in lighting phase

D. Three-position selector for function

 OFF = Stove shut off manually in absence of remote control

 REMOTE = Stove can be controlled only by remote control

 ON = Stove turned on manually in absence of remote control

 ON STEADY = Stove on

C. RED LED to indicate:

E. Three-position selector for selection of power

 OFF = Stove on

 FLASHING SLOWLY = Stove shutting down

 FLASHING RAPIDLY = Stove in alarm status

(accompanied for 10 minutes by a beep)

 ON STEADY = Stove off

 MIN = Selector to run the stove at minimum power with no remote control and with selector 4 in ON position

 MED = Selector to run the stove at medium power with no remote control and with selector in ON position

 MAX = Selector to run the stove at maximum power with no remote control and with selector in ON position

F. Push button for diagnostics of stove operating status

G. button to connect the stove to a new remote control (by means of a procedure explained below)

TO OPERATE THE STOVE WITH THE REMOTE

CONTROL, SELECTOR "D" MUST BE PLACED

ON “REMOTE”

Operation Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited