Control Two JVC VCRs. JVC HR-J7005UM

NUMBER "1"

1

4

7

POWER

2

5

8

0

3

NUMBER "2"

2

6

9

4

STOP

1

3

A/B

EN

41

Control Two JVC VCRs

The remote control is capable of controlling two JVC VCRs independently; one set to respond to your remote control's A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your VCR is initially set to respond to A code signals.

You can easily modify your VCR to respond to B code signals.

UNPLUG VCR'S POWER

CORD

Unplug from the AC outlet.

1

2

SET REMOTE CONTROL

CODE

While holding down A/B on the remote control, press the NUMBER key "2" and then press STOP.

PLUG IN POWER CORD

Plug back in to the AC outlet.

3

TURN VCR POWER ON

Press POWER on the remote.

4

The VCR will now respond only to B-code commands.

To set the VCR back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key

"1" instead of "2" in step 2.

You can control two VCRs with the same remote control by switching the remote's code between A and B ( Z Step 2).