advertisement
![4.5.2 Configuration Setting. Planet POE-2400, POE-1200 | Manualzz 4.5.2 Configuration Setting. Planet POE-2400, POE-1200 | Manualzz](http://s1.manualzz.com/store/data/003392338_1-b3c95b72887b90b2f7e2b26bb9163a60-360x466.png)
4.5.2 Configuration Setting
This function allows backup and restore the current configuration of PoE Injector Hub, or reset the converter to factory default. The description of the three items as follow and screen in Figure 4-10 appears.
■ Backup - To backup/save the current configuration to the storage block on this converter.
■ Restore – To restore the previous backup configuration from the storage block.
■ Factory – To reset the Injector Hub back to the factory default mode.
Figure 4-10 Tools\Configuration Setting screen
■
Backup
All current configurations (except IP Configuration) will save to converter as backup once the “Backup” button is pressed.
Figure 4-11 Tools\Configuration Setting\Backup screen
After the “Backup” button is pressed and success backup current configuration, the screen in Figure 4-12 appears
Figure 4-12 Configuration backup successes screen
22
■
Restore
The PoE Injector Hub will restore to previous backup/saved configuration while the “Restore” button be pressed. And please note that once the Restore button be pressed, Web interface will disconnected for a while. Reload the Web browser to re-login the system.
Figure 4-13 Configuration restore screen
■
Factory Reset
The Factory Reset button can reset the PoE Injector Hub back to the factory default mode. Be aware that the entire configuration will be reset, and the IP address of the PoE Injector Hub will be set to “192.168.0.100”.
Figure 4-14 Factory Reset screen
Once the Factory Reset item is pressed, the screen in Figure 4-15 appears.
Figure 4-15 Factory Reset screen
23
advertisement
Related manuals
advertisement
Table of contents
- 4 1. INTRODUCTION
- 8 2. INSTALLATION
- 8 2.1.1 Injector Front Panel
- 9 2.1.2 LED Indicators
- 9 2.1.3 Injector Rear Panel
- 10 2.2.1 Desktop Installation
- 11 2.2.2 Rack Mounting
- 12 2.2.3 Network Application Installation
- 13 2.2.4 Power over Ethernet Powered Device
- 14 3 MANAGEMENT
- 14 3.3.1 Web Management
- 16 3.3.2 PLANET Smart Discovery Utility
- 18 4 WEB CONFIGURATION
- 20 4.3.1 System Information
- 20 4.3.2 IP Configuration
- 21 4.3.3 Password Setting
- 24 4.5.1 System Reboot
- 25 4.5.2 Configuration Setting
- 27 4.5.3 Alert Trap Configuration
- 28 4.5.4 Firmware Upgrade
- 31 5. POWER OVER ETHERNET OVERVIEW
- 33 6. THE POE PROVISION PROCESS
- 35 7 TROUBLESHOOTING
- 36 APPENDIX A
- 39 APPENDIX B