Appendix C. Omron NT-series NT600S-ST211(B)-EV3, NT-series NT600S-ST121(B)-EV3, NT-series NT20S-ST161-EV3, NT-series NT20S-ST121-EV3, NT-series NT20S, NT-series NT20M-DT131, NT-series NT20S-ST168, NT-series NT20S-ST128, NT-series NT20S-ST122-V1
जाहिरात
जाहिरात
Handling the RS-232C/RS-422 Converter Unit Appendix C
APPENDIX C
Handling the RS-232C/RS-422A Converter Unit
This section shows the dimensions of the RS-232C/RS-422A converter unit (NT-AL001), and describes the methods for installing and removing it. Refer to this information when designing the control panel.
Dimensions
53.5
(2.11)
110
(4.33)
4
(0.16)
74.5 (2.93)
100.2 (3.94)
105 (4.13) or less
[30]
(1.18) om R on NT-AL001
45 (1.77)
30 (1.18)
Unit = mm (in.)
With RS-422A terminal block cover closed:
30 [1.18] (W) x 114 [4.49] (H) x 100.2 [3.94] (D) mm [in.]
With RS-422A terminal block cover open:
30 [1.18] (W) x 114 [4.49] (H) x 119.5 [4.7] (D) mm [in.]
Installation and Removal
The RS-232C/RS-422A converter unit (NT-AL001) is installed on a DIN rail or in an operation panel.
The RS-422A terminal block of the converter unit can easily be removed.
249
Handling the RS-232C/RS-422 Converter Unit Appendix C
Installation on a DIN Rail
Hook the top part of the rear of the converter unit ((a) in the figure) onto the top edge of the DIN rail, and push the unit in direction (b).
Then fit end plates on the right and left sides of the converter unit so that the unit cannot shift sideways.
(a)
(b)
Removal from the DIN Rail
Remove the end plates at right and left, then insert a flat-tipped screwdriver into the rail stopper on the bottom of the unit and pry the unit away.
Installation in an Operation Panel
Make two screw holes in an operation panel wall at least 2 mm thick and secure the converter to the wall with screws.
30
(1.18)
100 (3.94) 110 (4.33)
21
(0.83)
2-M4
Unit = mm (in.)
Note: In order to ensure a strong installation, the wall of the operation panel must be at least 2 mm thick.
250
डाउनलोड
जाहिरात