Introduction. Schneider Electric Lexium Controller
ಜಾಹಿರಾತು
ಜಾಹಿರಾತು
6
Introduction
Presentation
The integrated communication port provides direct access to the Modbus protocol:
• The Modbus HMI RJ45 port, located on the front panel of the Lexium Controller is used to connect:
- The graphic display terminal
- A Magelis industrial HMI terminal
- A programmable controller (PLC)
- Another controller
- The Motion Pro/CoDeSys software workshop
The Modbus port on the Lexium Controller can be used for the following functions:
• Configuration
• Adjustment
• Control
• Monitoring
The Lexium Controller supports:
• The 2-wire RS485 physical layer
• RTU transmission mode
This manual describes how to set up the Lexium Controller on Modbus and the available Modbus services.
The slave address is configured using Motion Pro/CoDeSys
The Modbus network speed is 38.4 kbps.
It can be configured for 19.2, but this configuration limits use with Motion Pro/CoDeSys via the serial link.
LMC10/LMC20 LMC20Apppp
Modbus connector or graphic display terminal
ಡೌನ್ಲೋಡ್ ಮಾಡಿ
ಜಾಹಿರಾತು