5 Saving and Restoring All the Data. Sharp TINSZ2602RCZZ, XE-A42S, XE-A406

A42S_5 FOR THE MANAGER_SD 09.10.14 9:12 AM Page 72

72

5

Saving and Restoring All the Data

Set the mode switch to the PGM position.

Saving (writing) all the data

The comfirmation message is printed.

s 144 @ s

To execute

1

*

A l

To cancel

Restoring (reading) the saved data

The comfirmation message is printed.

s 148 @ s

To execute

1

*

A l

To cancel

* The message “ACCESSING CARD” will appear and stay on the display until all data is completely written or read. When writing or reading is finalized, the message “SD FINAL” will be printed. In case an error occurs, a corresponding error message will be printed.

If you save all the data by using an SD memory card that contains some data, the existing data will be erased and replaced with newly saved data. If you need the existing data, use another SD memory card.

6

Writing and Reading of Programming Data

Reading the graphic logo data

Set the mode switch to the PGM position.

The comfirmation message is printed.

s 145 @ s

To execute

1

*

A l

To cancel

* The message “ACCESSING CARD” will appear and stay on the display until all data is completely read. When reading is finalized, the message “SD FINAL” will be printed. In case an error occurs, a corresponding error message will be printed.