Connection with the mains. EuroLite LED TL-3 TCL 3x3W Trusslight


Add to My manuals
32 Pages

advertisement

Connection with the mains. EuroLite LED TL-3 TCL 3x3W Trusslight | Manualzz

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.

The occupation of the connection-cables is as follows:

Yellow/Green Earth

The earth has to be connected!

If the device will be directly connected with the local power supply network, a disconnection switch with a minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.

The device must only be connected with an electric installation carried out in compliance with the IECstandards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of 30 mA.

Lighting effects must not be connected to dimming-packs.

Connection between devices

On the side panel, there is a socket (Power Out). Connect the output with the mains input of the next fixture until all fixtures are connected.

Please note: A maximum of 8 devices may be linked together. After every 8 devices, the fixtures must have a renewed connection with the power mains.

OPERATION

After you connected the LED TL-3 TCL 3x3W to the mains, it starts running.

The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and

DOWN.

The device has three operating modes. It can be operated in Stand Alone Mode via the Control Board, via optionally available EUROLITE IR-7 remote control or in DMX-controlled mode via every standard DMX controller.

Please refer to the instructions under Control Board.

25/32 00080438.DOC, Version 1.1

advertisement

Related manuals