Return Path Setup. Wegener iPUMP 6400

iPump 6400 User’s Manual

Return Path

Setup

The Return Path is the communications return channel used for delivering status and reporting information to the network control system. When setting or changing the Return

Path Server IP address, be sure to enter a valid IP address corresponding to the address given to you by your Network Control Administrator. Entering the wrong IP address here prohibits status information from being delivered to the network control system.

1. From the Setup tab, select ReturnPath from the Setup tab’s drop-down menu.

2. Click the Edit button under Return Path Settings to change that group of parameters.

3. Update the parameters by changing the text in the text boxes.

iPump 615

Setup

4. To save your changes, click the Update button. Any changes take effect immediately. To discard any changes, click the Cancel button. Selecting Updateor Cancel returns you to the previous screen.

The iPump 615 is a peripheral decoder device capable of decoding MPEG2 Program

Streams delivered across a LAN (Local Area Network). Use the iPump 615 Settings to have the iPump 615 decode a stream.

1. From the Setup tab, enter the iPump 615 IP Address, Stream Address and Stream Port settings in the text boxes.

2. To send a one-time command to the iPump 615, click the Submit button.

3.9 iPump 6400 Operations by Function

Most iPump 6400 functions can be performed either locally from the front panel or from a web browser attached to the iPump 6400 via an Ethernet. Web browser operation is described in this section because after the initial configuration, most users use the web browser rather than the front panel. Operations are listed and described by function.

Monitor iPump 6400

Status

Monitor iPump 6400 status as follows:

1. Enter the iPump 6400's IP address in the address bar of the web browser.

2. The iPump 6400 Status tab automatically displays.

3. Click the Show Parameters button for additional system parameters or click the Clear

Diagnostics button to clear the Signal Quality diagnostic counts.

www.wegener.com

800009-01 Rev. J 43