Energy Saving Settings Menu. Ricoh PJ WX4152NI, PJ WX4152N, Ricoh PJ WX4152Ni

116

7. Changing the Projector Settings

Energy Saving Settings Menu

Item

Lamp Power

Select the lamp power level.

To save energy, select the eco mode. To make images brighter, select the standard mode.

The lamp power is switched to the standard mode regardless of this setting when [DICOM Sim. Mode], [3D Projection], or [Interactive

Mode] is enabled.

• Eco

• Stnd.

Lamp Pwr on No Signal

Specify whether or not to lower the lamp power when there is no input signal. If you select [Eco], the projector lowers the lamp power thirty seconds after the input signal disappears.

• Eco

• Stnd.

Image Eco

Specify whether or not to switch the lamp power automatically depending on the brightness of the image.

This function does not work when [DICOM Sim. Mode], [3D

Projection], or [Interactive Mode] is enabled.

Power Off on No Signal

Select the amount of time from the last input signal or operation until the projector enters standby mode.

• Off

• 5 min.

• 10 min.

• 20 min.

• 30 min.

Stnd.

Eco

On

20 min.

Default

Energy Saving Settings Menu

Item

Power on Standby

Specify whether or not to save energy while in standby.

• Eco

You can save energy while in standby, but start-up time is slower.

• Q'ck On

You can turn on the projector quickly, but the standby energy level is higher.

Eco

Default

NW Settings on Standby

Select a network function to be enabled while in standby. You can save energy by disabling the network function.

This function is available when you select [Eco] in [Power on Standby].

• Do not Use

Disable the wired LAN and the wireless LAN while in standby to save energy. To use the wired LAN or the wireless LAN, press the

[Power] button to turn on the projector.

• Wired LAN

You can turn on the projector from standby mode via a wired

LAN.

• Wired/Wireless LAN

You can turn on the projector from standby mode via a wired LAN or wireless LAN.

Wired LAN

• The image may flicker, depending on the characteristics of the lamp, when the lamp power is cut by the lamp settings. If this happens, specify the lamp settings as follows:

• Lamp Power: Stnd.

• Lamp Pwr on No Signal: Stnd.

• Image Eco: Off

117