Axis control. Fagor CNC 8055 for lathes, CNC 8055, CNC 8055 for milling machines, CNC 8055 for other applications

2.

Operating manual

2.2

Axis control

2.2.1

Work units

When accessing the CO mode, the CNC assumes the work units "mm or inches", "radius or diameter", "mm/min. or mm/rev", etc. selected by machine parameter.

To modify those values, access the M/T mode and change the corresponding machine parameter.

2.2.2

Coordinate preset

The coordinates must be preset on one axis at a time proceeding as follows:

[X] value [ENTER] [Z] value [ENTER]

The CNC requests confirmation of the command.

Pressing [ESC] quits the preset.

2.2.3

Managing the axis feedrate (F)

To set a particular axis feedrate value, proceed as follows:

[F] value [START].

Pressing [ESC] quits the selection.

CNC 8055

CNC 8055i

·MCO/TCO·

O PTION

·16·