34
K-r_OPM_ENG.book Page 34 Thursday, September 30, 2010 2:57 PM
How to Change Function Settings
1
Function settings can be changed using the direct keys, control panel or menus.
This section explains the basic ways to change function settings.
Using the Direct Keys
In Capture mode, you can set Drive Mode, Flash Mode, White Balance and Sensitivity by pressing the four-way controller ( 2345
). (p.86)
Below, how to set [Flash Mode] is explained as an example.
1
Press the four-way controller ( 3 ) in Capture mode.
The [Flash Mode] screen appears.
2
Use the four-way controller
( 45 ) to select a flash mode.
Flash Mode
Auto Flash Discharge
3
Press the 4 button.
The camera is ready to take a picture.
MENU Cancel
0.0
OK OK
