K-r_OPM_ENG.book Page 35 Thursday, September 30, 2010 2:57 PM
When direct key operation is enabled, the guide indicators for the direct keys are displayed in the status screen. Direct key operation is not available when the AF point is being changed while the focusing area is set to S (Select). In such cases, press and hold the 4
button. (p.130)
Using the Control Panel
While shooting, the current settings can be checked on the status screen.
You can also switch the display to the control panel and change settings.
Below, how to set [JPEG Quality] is explained as an example.
1
Check the status screen and then press the M button.
The control panel appears.
1
35
Press the M button when the status screen is not displayed.
AUTO
PICT
1/ 20
ISO
AUTO
800
-3 2 1 1 2 +3
AWB
AF.A
F 5.6
ISO
JPEG 12
M
[ 37 ]
2
Use the four-way controller
( 2345 ) to select an item you want to change the setting for.
You cannot select items that cannot be changed.
Custom Image
Bright
AF.A
JPEG 12
M
HDR
OFF
[ 37 ]
K-r_OPM_ENG.book Page 36 Thursday, September 30, 2010 2:57 PM
36
3
Press the 4 button.
The setup screen of the selected item appears.
1
JPEG Quality
JPEG
AF.A
12
M
HDR
OFF
[ 37 ]
4
Use the four-way controller
( 45 ) or e-dial to select a setting value.
JPEG Quality 128
MENU Cancel OK OK
5
Press the 4 button.
The camera returns to the control panel and is ready to take a picture.
• You can also change the setting by turning the e-dial after selecting the item you want to change in Step 2. Detailed settings such as parameters can be changed after pressing the 4 button.
• The status screen and control panel are not displayed when Live View
(p.159) is displayed. Make or change necessary settings in the [
A Rec.
Mode] menu in advance.
