Hercules Router 802.11G-54

1.

YOUR HERCULES ROUTER

Your Hercules Router opens up the doors of WiFi for you, allowing you to discover a new way of

communicating between several computers, sharing Internet access, peripheral devices, data and more… all without the constraints of cables.

Great care has been taken in designing your product. Both simple to operate and user-friendly, it is well suited to beginners and advanced users alike.

And now, it’s time to learn about your new product and join in the Wireless Attitude TM !

1.1.

Recommendations

- Never open up your Hercules Router, as you risk damaging its internal components.

- In order to avoid the risk of fire or electrical discharge, keep your router away from:

- rain or humidity, as well as all fluids (water, chemical products and any other liquids),

- sources of heat such as radiators, stoves and any other heat-producing devices (including amplifiers),

- direct sunlight.

- Do not cover your router.

- Unplug the router’s power cable if you do not plan on using it again for an extended period of time. To unplug the power cable, take hold of and pull on the plug. Never pull on the cable itself.

- Disconnect the router before cleaning. Use a soft cloth for cleaning and avoid using aerosol cleaners.

1.2.

Specifications

Your Hercules Wireless G Router, referred to hereafter in the manual as the Hercules Router, is equipped

with several functionalities: (1) WiFi 802.11g

wireless

router , (2) 10/100 LAN switch, and (3) Internet firewall.

ƒ WAN mode support (PPPoE, automatic DHCP, static IP)

ƒ LAN mode support

ƒ Router mode support

ƒ

802.11g

wireless access point

ƒ RF specification: frequency band = 2400-24835MHz

ƒ Max. transmission power: 100mW

ƒ One internal antenna, one slewable external antenna

ƒ 4 RJ-45 connectors for 10/100Mbps LAN Ethernet connection

ƒ Auto MDIX support (automatic detection of crossed cabling)

ƒ Complies with the IEEE 802.3u standard

ƒ Supports IEEE 802.3x flow control in Full Duplex mode

ƒ Security functions:

WEP

/

WPA -PSK/WPA2-PSK/Mixed WPA-WPA2, filtering by

MAC address

ƒ

SPI firewall

ƒ External CC power, input: 200~240V, 50/60Hz, output: 9 V CC/1 A

ƒ Green LEDs on front face

ƒ Software (firmware) update via Ethernet port

4/82 – User Manual