Spirolab
User manual
Bluetooth interface
Battery pack lifespan
Power supply
Battery charger
Dimensions
Weight
Type of electrical protection
Frequency range: 2402-2480 MHz
Output power: 0,001W
Frequency tolerance: 20 ppm
Type of antenna: permanently attached
Antenna gain: 0 max dBi
About 10 years of use
NiMH rechargeable 7.2V battery pack (6 batteries, 1.2V each), 4000 mAh
Model AC/DC 12W-N1EFM
Main body 220x210x51 mm;
Central unit 1450 g (including battery pack)
Class II
BF Degree of electrical protection
Degree of protection against water penetration
Safety level in the presence of flammable anaesthetic gases, oxygen and nitrogen
Conditions of use
IPX1 appliance protected against water leaks
Appliance not suitable
Storage conditions
Transport conditions
Device for continuous use
Temperature: MIN -40 °C, MAX + 70 °C
Humidity: MIN 10% RH; MAX 95%RH
Temperature: MIN -40 °C, MAX + 70 °C
Humidity: MIN 10% RH; MAX 95%RH
Operating conditions
Applicable standards
Temperature: MIN + 10 °C, MAX + 40 °C;
Humidity: MIN 10% RH; MAX 95%RH
Electrical Safety IEC 60601-1
Electro Magnetic Compatibility IEC 60601-1-2
Key performance (in accordance with
EN 60601-1: 2007)
2.
USING THE SPIROLAB
Accuracy in measuring spirometry parameters in accordance with the ATS standard
Measurement of oximetry parameters with accuracy as defined in the table on page 13
2.1
Turning the spirolab on and off
To turn the spirolab on, press then release the button on the front of the unit.
When you turn on the device, the first screenshot shows the internal software loading progress.
The display will automatically display the main menu after a few seconds.
Rev.1.3 Page 13 of 34
