Environmental Conditions. MPC UC009Tw, UC006Tw, UC012, UC022, UC015w, UC023w, UC015, UC022w, UC010

Environmental Conditions

This unit, and operations, will comply with DIN EN 61010-1:2001, only when it is located in suitable environmental conditions.

- for indoor use only;

- installation site ≤ 2000 m altitude;

- installed on a level, even, non flammable surface;

- maintain a clearance above and around the unit of 10 cm for water-cooled units, and 20cm for air-cooled units, to allow air to circulate around the unit;

- for ambient temperature conditions please refer to the technical data sheet; remaining within these ambient conditions is imperative in ensuring accurate operation;

- maximum relative humidity of 80% up to 32°C, decreasing linearly to 50% relative humidity at 40°C

- use only as long a power cord as necessary;

- the unit should be located so as not to restrict access to the mains power switch;

- mains voltage should be ±10% of the rated value;

- avoid voltage spikes;

- transient voltage surges as they occur normally in the supply grid;

- clean rating 2;

- overvoltage category II

11