advertisement
2.5. Setting Valid Card (LED) Flash
The Smart Card Reader allows for the blue LED to give a short flash when a valid card is badged (on during credit transactions). There are two ways to enable this option:
1.
Using a configuration card programmed with the Smart Card Programmer ATS1620 and the ATS8100
Titan Software package. This can be done when setting the address.
2.
Using the Smart Card Reader menu.
Method
1. Change the valid card flash operation while setting the address by programming a configuration card using the TITAN system management software and the
Smart Card programmer (ATS
1620).
Procedure
1.
Set the address as described under
Setting the reader’s address
method 1, steps 1 and 2.
2.
To enable, tick the Valid card LED flash checkbox.
3.
Follow steps 3 through 5 as described under
Setting the reader’s address
.
2. Change the valid card flash operation using the Smart Card
Reader menu.
1.
Return to the Smart Card Reader menu as described under Programming information in the Smart Card Reader.
Tecom Smart Reader TS0870
0-Exit, Menu: _
2.
Press 3 [ENTER] to enter the Valid Card Flash setting.
One of two screens appear:
Flash Enabled
*-Change, #-Exit
Or
Flash Disabled
*-Change, #-Exit
Default: Flash Enabled
3.
Use [Menu*] to toggle between the options.
4.
Press [ENTER] to exit the option. The display will show
Valid Card Flash menu.
3-Valid Card Flash
0-Exit, Menu: _
Exception
: If a credit deduction was made from the card, the blue LED turns on for the duration of the transaction, regardless of this menu option. See the section on “Credit
Set-up” for more details.
10 ATS1190 Programming Manual
advertisement