advertisement
2.17. Setting the security mode
The security mode is used to determine if programmed Smart Cards with credits and user defined cards can be read, or only blank, unprogrammed cards with a unique serial number and user defined cards. To use the unsecured mode, a special memory module is required. This option can be set using one of two methods:
1.
Using a configuration card programmed with the Smart Card Programmer ATS1620 and the ATS8100
Titan Software package. This can be done when setting the address.
2.
Using the Smart Card Reader menu.
Method
1. Set the security mode when setting the address by programming a configuration card using the TITAN system management software and the Smart Card programmer (ATS
1620).
Procedure
1.
Set the address as described under
Setting the reader’s address
method 1, steps 1 and 2.
2.
Select the required option in the list box labelled Security mode.
3.
Follow steps 3 through 5 as described under
Setting the reader’s address
.
2. Set the security mode using the
Smart Card Reader menu.
1.
Return to the Smart Card Reader menu as described under Programming information in the Smart Card Reader.
Tecom Smart Reader TS0870
0-Exit, Menu: _
2.
Press 16 [ENTER] to enter the security mode setting. One of two screens appears:
Secured mode
*-Change, #-Exit
Or
Unsecured mode
*-Change, #-Exit
Default: Secured
3.
Use [Menu*] to toggle between the options.
4.
Press [ENTER] to exit the option. The display shows the
Option Card menu.
16- Security mode
0-Exit, Menu: _
Note: To enable option cards again, use the Smart Reader
Menu to enable the option again, default the reader or set this option in a configuration card if this option has not been used yet already. After disabling this option, a configuration card can only be used once.
24 ATS1190 Programming Manual
advertisement