4.5.14 ERPS. Advantech EKI-7706E-2F, EKI-7706E-2FI, EKI-7706G-2F, EKI-7706G-2FI
Add to My manuals173 Pages
advertisement
4.5.13.2
Port Settings
The Port Settings page allows you to select ports that are detected by the loopback detection function and configure their status (enabled or disabled).
To access this page, click L2 Switching > Loopback Detection > Port Settings .
Figure 4.57 L2 Switching > Loopback Detection > Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Enabled
Description
Enter the port to define the local loopback detection setting.
Select Enabled or Disabled to setup the Loopback Detection function.
Click Apply to save the values and update the screen.
Apply
The ensuing table for Loopback Detection Port Information settings are informational only: Port, Enable State and Loop Status.
4.5.14
ERPS
4.5.14.1
ERPS Settings
To access this page, click L2 Switching > ERPS > ERPS Settings .
Figure 4.58 L2 Switching > ERPS > ERPS Settings
The following table describes the items in the previous figure.
Item
State
Apply
Description
Click Enabled or Disabled to enable ERPS settings.
Click Apply to save the values and update the screen.
The ensuing table for Information settings are informational only: ERPS State.
73 EKI-7706 Series User Manual
4.5.14.2
ERPS Groups
To access this page, click L2 Switching > ERPS > ERPS Groups .
Figure 4.59 L2 Switching > ERPS > ERPS Groups
The following table describes the items in the previous figure.
Item
ERP Instance
Ring ID
Role
East Link
RPL
West Link
RPL
MEL
R-APS Channel
VLAN
Traffic Channel
Instance
Type
WTR Timer
Guard Timer
Hold-off Timer
Apply
Description
Enter the value to set the ERP instance.
Enter the value to set the ring ID.
Click the drop down menu to select the role. Options include: RPL
Owner, RPL Neighbor or Other.
Enter the port to define the east link.
Check the check box to enable RPL.
Enter the port to define the west link.
Check the check box to enable RPL.
Enter the value to set minimum equipment list.
Click the drop down menu to select the VLAN.
Click the drop down menu to select the traffic channel instance.
Click the drop down menu to select the ERP group type.
Enter the value to set WTR timer.
Enter the value to set guard timer.
Enter the value to set hold-off timer.
Click Apply to save the values and update the screen.
The ensuing table for Information settings are informational only: ERP Instance,
Ring ID, Role, State, East Link, West Link, MEL, R-APS Channel VLAN, Traffic Channel Instance, Type, WTR Timer, Guard Timer, Hold-off Timer and Delete (Click
Delete to delete the desired Ring ID).
EKI-7706 Series User Manual 74
advertisement