Change bump/cal interval. MPower MP100
Add to My manuals24 Pages
MPower MP100 is a portable personal gas monitor with a large LCD screen for easy viewing of gas concentrations. It can display real-time readings, as well as STEL, TWA, peak and min values. It has configurable high, low, STEL, and TWA alarm thresholds, and can be used to monitor a variety of gases, including CO, H2S, SO2, O2, and VOCs. The MP100 is easy to use, with two-key operation and a simple menu system. It is also durable and has a long battery life.
advertisement
MP100 User’s Guide
Use the Left Key to increase the current digit,
Use the Right Key to move cursor to the next digit:
, cycle from 0 to 9.
After all digits are done, use the Right Key to move cursor to “OK” symbol, press the Left Key to confirm the changing.
* MP100 will show “Err”, if the input data is invalid as follows,
- Low alarm setting is bigger than high alarm setting.
- High alarm setting is smaller than low alarm setting.
- Input data is bigger than measuring range.
Change bump/cal interval
The bump and cal interval can also be changed. When LCD switches between:
, and , and , press the Left
Key to change the corresponding interval range, the value change process is similar.
First the current setting value is displayed, with the first digit flashing: .
Use the Left Key to increase the current digit, , cycle from 0 to 9.
Use the Right Key to move cursor to the next digit:
After all digits are done, use the Right Key to move cursor to “OK” symbol,
11
,
advertisement
Related manuals
advertisement
Table of contents
- 3 Read Before Operating
- 4 General Information
- 4 User Interface
- 5 Display
- 6 Using MP
- 6 Turn the unit on
- 6 Warm up sequence
- 7 Normal mode
- 7 Real time reading
- 7 STEL screen
- 7 TWA screen
- 7 Peak screen
- 8 Min screen (for Oxygen sensor only)
- 8 Turn the unit off
- 8 Config mode
- 8 Enter Config mode
- 9 Sensor calibration
- 9 Calibration adapter
- 10 Zero calibration
- 10 Span calibration
- 11 Bump test
- 11 Change alarm limit
- 12 Change bump/cal interval
- 13 Change span value
- 13 Change display unit
- 13 Vibrator enable/disable
- 14 Power on zero enable/disable
- 14 Fast power on enable/disable
- 14 Reset config
- 15 Exit Config mode
- 15 Maintenance
- 15 Replace the battery
- 16 Replace the sensor filter
- 16 Replace the sensor
- 18 Ordering information
- 19 Specifications
- 20 Sensor configuration
- 21 Alarm signal summary
- 23 Trouble shooting