The installation of the handle. Caso Design CASO WineChef Pro 40 black

12.5.2 Feet

You can adjust the height of the device with the adjustable feet:

Please note

► You can reach the maximum height of the device of 875 mm by unscrewing the adjustable feet as far as possible. Secure the nuts with an open-end wrench.

► For the minimum height of the device of 820 mm, remove the nuts from the adjustable feet and screw them in completely.

1. Measure the height of the niche in which the device is to be placed.

2. Tilt the device forward slightly.

Adjust the height of the device with the rear adjustable feet.

3. Tilt the device back slightly. Adjust the height of the device with the front adjustable feet.

4. Place the device at the installation site without any lateral pressure.

5. Tilt the device back slightly and then use the front feet to adjust the device.

12.5.3 The installation of the handle

The wine cooler comes with one metal stainless steel handle. To install simply screw them to the door with the supplied screws.

To do this, slide the rubber seal on the back of the door to the side to lay open the predrilled holes. Use the included screws to install the handle on the door.