advertisement
![Training Course. Can-Am Outlander 400 EFI CE | Manualzz Training Course. Can-Am Outlander 400 EFI CE | Manualzz](http://s1.manualzz.com/store/data/067534381_1-3402ffaf2430e6835c0fe6a36c0720f2-360x466.png)
SPECIAL SAFETY MESSAGES
WARNING
Passenger must:
– Never take place on this vehicle without wearing an approved helmet (including a chin guard) that fits properly. You should also wear eye protection (goggles or face shield), gloves, boots, long sleeved shirt or jacket, and long pants.
– Be seated on the designated passenger's seat and hold on to the grab handles at all times. Never hold on to the operator.
– Always keep hands and feet in the proper place during operation.
– Never get up during vehicle operation. An excessive movement could cause loss of control.
– Pay attention to vehicle and operator movements.
– Not wait and tell the driver to slow down or stop if you feel uncomfortable or insecure for any reason.
Training Course
Never operate this vehicle without proper instruction.
Take a training course.
All operators should receive training from a certified instructor.
FOR MORE INFORMATION ABOUT ATV SAFETY , contact an authorized
Can-Am dealer to find out about available training courses nearest you.
12
_______
SAFETY INFORMATION
________
advertisement
Related manuals
advertisement
Table of contents
- 14 Training Course
- 15 European Community
- 16 OPERATION WARNINGS
- 45 RIDING THE VEHICLE
- 46 Pre-Ride Inspection
- 48 Clothing
- 49 Carrying a Passenger
- 50 Carrying Loads
- 50 Hauling a Trailer
- 51 Working with your Vehicle
- 51 Recreational Riding
- 52 Environment
- 52 Design Limitation
- 52 Off-Road Operation
- 53 General Operating and Safety Precautions
- 55 Riding Techniques
- 64 IMPORTANT ON-PRODUCT LABELS
- 64 Hang Tag
- 66 Vehicle Safety Labels
- 70 Compliance Labels
- 70 Technical Information Labels
- 72 CONTROLS/INSTRUMENTS/EQUIPMENT
- 75 1) Throttle Lever
- 75 2) 2WD/4WD Selector
- 76 3) LH Brake Lever
- 76 4) Brake Lock
- 77 5) Shift Lever
- 78 6) Headlight Dimmer Switch
- 78 7) Emergency Engine Stop Switch
- 79 8) Engine Start Button
- 79 9) Override Button
- 79 10) Multifunction Gauge
- 84 11) 12-Volt Power Outlet
- 85 12) Ignition Switch
- 86 13) Brake Pedal
- 86 14) Footpeg
- 86 15) Grab Handles
- 87 16) Passenger's Seat
- 88 17) Storage Box
- 89 18) Operator's Seat Latch
- 90 19) Rear Storage Compartment
- 90 20) Cargo Racks
- 91 21) Trailer Hitch
- 91 22) Tool Kit
- 91 23) Winch
- 92 24) Winch Control Switch
- 92 25) Vehicle Lock
- 92 26) Turn Signal Switch
- 92 27) Horn Button
- 93 28) Hazard Warning Button
- 93 29) Winch Remote Control
- 94 Recommended Fuel
- 94 Fueling Procedure
- 95 BREAK-IN PERIOD
- 95 Operation During Break-In
- 96 BASIC PROCEDURES
- 96 Starting the Engine
- 96 Changing Gear Selection
- 96 Stopping the Engine
- 97 SPECIAL PROCEDURES
- 97 What to Do if Water is in the CVT
- 97 What to Do if Water is in the Air Filter Housing
- 97 What to Do if Vehicle is Turned Over
- 97 What to Do if Vehicle is Immersed in Water