advertisement
![17) Storage Box. Can-Am Outlander 400 EFI CE | Manualzz 17) Storage Box. Can-Am Outlander 400 EFI CE | Manualzz](http://s1.manualzz.com/store/data/067534381_1-3402ffaf2430e6835c0fe6a36c0720f2-360x466.png)
CONTROLS/INSTRUMENTS/EQUIPMENT
NOTE: A distinctive snap will be felt.
Double check that the seat is secure by giving it a tug to confirm proper latching.
WARNING
It is of the upmost importance for the passenger's safety that you confirm that the passenger's seat is properly locked in position by pulling back and up several times.
17) Storage Box
2-UP Models
WARNING
Never operate the vehicle without storage box properly installed.
The storage box is used to convert a two-rider vehicle (2-UP model) to a one-rider vehicle (1-UP model) with extra cargo capacity.
WARNING
Without its passenger's seat, the vehicle becomes a ONE RIDER vehicle (1-UP model) and NO PAS-
SENGER must be allowed on vehicle. NEVER carry passenger on storage box.
Storage Box Installation
Remove passenger's seat, refer to
PASSENGER'S SEAT REMOVAL
.
Position storage box onto rear fender.
When storage box rests in its position, firmly push down to latch.
To open storage box, unhook the rubber latch.
vmo2008-016-006_a
1. Storage box
The conversion of the vehicle is easy, remove the passenger's seat then install the storage box.
vmo2008-001-003_b
1. Rubber latch
Storage Box Removal
Pull storage box strap to release from vehicle.
Remove storage box.
Reinstall passenger's seat, refer to
PASSENGER'S SEAT INSTALLATION
.
86
______________
advertisement
Related manuals
advertisement
Table of contents
- 14 Training Course
- 15 European Community
- 16 OPERATION WARNINGS
- 45 RIDING THE VEHICLE
- 46 Pre-Ride Inspection
- 48 Clothing
- 49 Carrying a Passenger
- 50 Carrying Loads
- 50 Hauling a Trailer
- 51 Working with your Vehicle
- 51 Recreational Riding
- 52 Environment
- 52 Design Limitation
- 52 Off-Road Operation
- 53 General Operating and Safety Precautions
- 55 Riding Techniques
- 64 IMPORTANT ON-PRODUCT LABELS
- 64 Hang Tag
- 66 Vehicle Safety Labels
- 70 Compliance Labels
- 70 Technical Information Labels
- 72 CONTROLS/INSTRUMENTS/EQUIPMENT
- 75 1) Throttle Lever
- 75 2) 2WD/4WD Selector
- 76 3) LH Brake Lever
- 76 4) Brake Lock
- 77 5) Shift Lever
- 78 6) Headlight Dimmer Switch
- 78 7) Emergency Engine Stop Switch
- 79 8) Engine Start Button
- 79 9) Override Button
- 79 10) Multifunction Gauge
- 84 11) 12-Volt Power Outlet
- 85 12) Ignition Switch
- 86 13) Brake Pedal
- 86 14) Footpeg
- 86 15) Grab Handles
- 87 16) Passenger's Seat
- 88 17) Storage Box
- 89 18) Operator's Seat Latch
- 90 19) Rear Storage Compartment
- 90 20) Cargo Racks
- 91 21) Trailer Hitch
- 91 22) Tool Kit
- 91 23) Winch
- 92 24) Winch Control Switch
- 92 25) Vehicle Lock
- 92 26) Turn Signal Switch
- 92 27) Horn Button
- 93 28) Hazard Warning Button
- 93 29) Winch Remote Control
- 94 Recommended Fuel
- 94 Fueling Procedure
- 95 BREAK-IN PERIOD
- 95 Operation During Break-In
- 96 BASIC PROCEDURES
- 96 Starting the Engine
- 96 Changing Gear Selection
- 96 Stopping the Engine
- 97 SPECIAL PROCEDURES
- 97 What to Do if Water is in the CVT
- 97 What to Do if Water is in the Air Filter Housing
- 97 What to Do if Vehicle is Turned Over
- 97 What to Do if Vehicle is Immersed in Water