advertisement
![16) Passenger's Seat. Can-Am Outlander 400 EFI CE | Manualzz 16) Passenger's Seat. Can-Am Outlander 400 EFI CE | Manualzz](http://s1.manualzz.com/store/data/067534381_1-3402ffaf2430e6835c0fe6a36c0720f2-360x466.png)
CONTROLS/INSTRUMENTS/EQUIPMENT
Passenger's Seat Removal
Pull one of the passenger's seat handles. Those handles are located underneath the RH and LH rear end of seat.
vmo2008-016-005_a
1. Grab handles
16) Passenger's Seat
2-UP Models
WARNING
Never operate the vehicle without passenger's seat properly installed.
The passenger's seat is designed specially to allow a secure and pleasant ride to ONE (1) passenger.
The integrated backrest supports his back during the ride.
vmo2006-008-009_a
LH SIDE SHOWN
1. Seat latch
Gently lift seat rearwards.
Continue lifting movement until you can release the retaining device then completely remove passenger's seat.
Passenger's Seat Installation
Insert passenger's seat positioning tubes into rear fender provided holes.
vmo2008-016-005_b
1. Passenger's seat
2. Integrated backrest vmo2006-008-010_a
TYPICAL
1. Holes for passenger's seat positioning tubes
When seat rests in its position, firmly push seat down to latch.
_______________
85
advertisement
Related manuals
advertisement
Table of contents
- 14 Training Course
- 15 European Community
- 16 OPERATION WARNINGS
- 45 RIDING THE VEHICLE
- 46 Pre-Ride Inspection
- 48 Clothing
- 49 Carrying a Passenger
- 50 Carrying Loads
- 50 Hauling a Trailer
- 51 Working with your Vehicle
- 51 Recreational Riding
- 52 Environment
- 52 Design Limitation
- 52 Off-Road Operation
- 53 General Operating and Safety Precautions
- 55 Riding Techniques
- 64 IMPORTANT ON-PRODUCT LABELS
- 64 Hang Tag
- 66 Vehicle Safety Labels
- 70 Compliance Labels
- 70 Technical Information Labels
- 72 CONTROLS/INSTRUMENTS/EQUIPMENT
- 75 1) Throttle Lever
- 75 2) 2WD/4WD Selector
- 76 3) LH Brake Lever
- 76 4) Brake Lock
- 77 5) Shift Lever
- 78 6) Headlight Dimmer Switch
- 78 7) Emergency Engine Stop Switch
- 79 8) Engine Start Button
- 79 9) Override Button
- 79 10) Multifunction Gauge
- 84 11) 12-Volt Power Outlet
- 85 12) Ignition Switch
- 86 13) Brake Pedal
- 86 14) Footpeg
- 86 15) Grab Handles
- 87 16) Passenger's Seat
- 88 17) Storage Box
- 89 18) Operator's Seat Latch
- 90 19) Rear Storage Compartment
- 90 20) Cargo Racks
- 91 21) Trailer Hitch
- 91 22) Tool Kit
- 91 23) Winch
- 92 24) Winch Control Switch
- 92 25) Vehicle Lock
- 92 26) Turn Signal Switch
- 92 27) Horn Button
- 93 28) Hazard Warning Button
- 93 29) Winch Remote Control
- 94 Recommended Fuel
- 94 Fueling Procedure
- 95 BREAK-IN PERIOD
- 95 Operation During Break-In
- 96 BASIC PROCEDURES
- 96 Starting the Engine
- 96 Changing Gear Selection
- 96 Stopping the Engine
- 97 SPECIAL PROCEDURES
- 97 What to Do if Water is in the CVT
- 97 What to Do if Water is in the Air Filter Housing
- 97 What to Do if Vehicle is Turned Over
- 97 What to Do if Vehicle is Immersed in Water